As a self- replacing faucet in the bathroom - step by step instructions

Replacing a faulty faucet in the bathroom is not difficult, even for someone who has already forgotten the last time I picked up anything heavier than a pen.Any man will cope with it without causing a locksmith from the housing department, in addition, that the mechanic still have to wait.But before you start to work yourself, you need to understand how to replace a faucet in the bathroom, some of the nuances of the procedure.Because ultimately we are dealing with water, which often flows not from where it should be, rather - leaks that joy of the owners, of course, does not matter.

Replacement faucet in the bathroom

work begins with the removal of old, faulty mixer.To begin to close the water tap in the apartment.At the bottom of the tub or the need to put a piece of old material or paper in several layers, and now for what purpose: when the mixer is replaced something (metal) can fall, for example, your wrench, and then scratching the coating bath can not be avoided.Cover the drain hole and should be - that there is often "fly" cogs and shaybochki.If the old faucet and defective, it does not mean that you will no longer be useful any item from it.Therefore, it must be carefully removed.

mixer is removed entirely, without disassembly.It is only necessary to unscrew those nuts that it is attached to the pipes (hot and cold water).If plastic pipe, hold them without dёrgayte key too.These "large" nuts come together with a mixer, so soon decide whether they should also be replaced or not.In any case, you will have stock.Enjoy the best wrench.When rusted nuts, not loosen, they need to thoroughly lubricate WD vehicle - 40, it more colloquially referred to as "liquid key."It eats away at the rust, the paint softens, salt deposits.After a while, you can easily turn any nut.

Before installing the new faucet, the threads of the pipe wrap "insulation" that protects from water leaks.It is better to use a so-called FUM - a tape that is sold in the same stores where and mixers.Say the seller, it is necessary to replace the mixer, and it advises certain width and thickness, since such tapes are of different types.

not forget to put on the pipe shiny washer before winding the tape.It serves to mask the junction.Drum band should be in the same direction, which will tighten the screws.

Tips:

• Pay attention to the correct installation of the sealing gasket !!!
• Do not tighten the nuts very much - mar pad.
• When replacing mixers are used in some cases, special adapters, inserts - but that's a different story.