Self-adhesive film for windows - conversion without brushes and paints

film for doors - the main characteristics of

Adhesive tape - material from PVC, which includes 2 layers: decorative and adhesive.Last supplemented by the top glossy paper, protecting it from damage.The decorative layer is covered with a further, so-called polyester layer.It protects against mechanical damage and high gloss surface.

top layer can mimic stone, marble, brick, velor, veneer valuable species of wood, metal, natural cork, and it can be plain or patterned the same.In general, the film has a wide color gamut.It is sold in rolls of various sizes.

Film for door has the following advantages:

• does not require special care;
• low cost;
• odorless;
• easy to use;
• does not hurt to paste over the surface;
• does not spoil the original appearance;
• durable and water-resistant.

But there are also disadvantages:

• not hide defects on the surface;
• can not be reused;
• ephemeral.

Preparatory work for pasting

doors before pasting should prepare a surface of the door.It needs to be cleaned of grease and stains.If earlier it was painted, and the old paint is beginning to peel, then you need to remove it.

Next, you need to polish the surface of a large sandpaper, and then walk again fine paper.This will make it more smooth.Then wipe it with a damp sponge, and then wash the door with soapy water and let it dry.

If there are defects on the door, then they should cover up putty, then sanding.Next you need to treat the surface of acrylic primer.Before pasting the door must be perfectly flat.

When the surface is ready, you need to remove the door awnings, remove handles and locks.The ends and place near the hinge treat plane.Then hang the door into place and make sure that when you close the gap remained about 1-2 mm.So the film will not deteriorate and fade.Now again, remove the door and get to work.

How to paste over the door film - do everything without haste

On the reverse side of the film is drawn centimeter scale.With it you can measure the required dimensions and cut her lines inscribed.The preform should be cut with a margin of 2-3 cm.

First, you can paste over the door end by bending the canvas door of 1-2 cm. And then you need to start the main part of the transformation, pasting a little bit on the edge, which was bent.The junction of this place should not be prominent.

not necessary to remove all the protective paper immediately.Should gradually come unstuck, remove the first 5 cm and glue film to the web.Then evenly and slowly draw off the paper down.Then smooth with a cloth to avoid bubbles.This should be done from the center outwards.If bubbles still formed, they have to pierce the needle and releasing the air press.

You can also get rid of the bubbles with a hair dryer.It is necessary to soften the film of hot air and re-flatten with a soft cloth.

Continue gluing thus be until the end.Next cut off all the allowances with a sharp knife.The blade should slide on the edges of the door, so as not to cut too much.Then iron the film at the edges.

Once the doors are plastered, you must cover the top cloth protective varnish.When everything is ready, put the handles and locks the door and hang it in place.Now it will attract attention for its novelty.A drawing of the film will emphasize the design of the room.

Knowing how to paste over the door of the film, do not have to be not to worry about what the appearance of the door to match your interior, because any time you can re-stick tape, and again she will be like new.