How to remove or dissolve the assembly foam with different surfaces ?

Removal of foam - the sooner, the better

However, in any case, before you clean the foam core by means of a substance, check its effect on hidden from the eyes of the surface area.For example, use a special cleaner foam can be only on the surface that is resistant to acetone.

reservation at once, that the removal of foam depends on the surface to be cleaned, and how she had to dry.First of all, find out than to remove the mounting foam, when it came to the surface relatively recently and has not yet hardened.

Obviously, it should be how to remove mechanically as soon as possible to try, ie,with a knife or staple.But this should be done very carefully so as not to scratch the surface.Of course, in this way it will be able to remove only the upper part of the pollution to continue to be resolved than to dissolve the assembly foam for final removing it.

How to remove already frozen assembly foam?

For removing all residues required solvent foam, such as for example Reiniger ,

Cosmofen or Fenozol .Convenient solvents are completely unsuitable as a trace their impact will be even more intensely penetrate deep into the surface, and thereafter removing stains become impossible.

And a special solvent for prolonged exposure is also able to have a negative impact, so it should be promptly removed with a damp cloth.

And now try to understand what can be cleaned mounting foam after it is completely dry.The first step is, as in the case of incomplete drying mechanically remove dirt upper part.But only the part that has no direct contact with the surface!

on remaining at the base layer is applied to the drug Dimexidum , which can be purchased without a prescription at the pharmacy.Under its influence residues softened and can be removed without damaging the surface.

How to clean a variety of surfaces from foam?

Already from foam purpose is clear that the substance is a high penetrating power, and therefore the removal of residues is always fraught with difficulties and the risk of pollution damage.Sometimes cope with this task helps mineral spirits, acetone, benzene, or ordinary.

However, there is always the chance of damage to the surface.Some reduce it possible, using foam cleaner.Good results are often provides the use of vegetable oil which is applied for 30 minutes on a foam residues, whereupon it softens and is easily removed from the surface.

With linoleum mounting foam should try to remove the usual water.After removing the knife frozen part, the remains should be placed wet cloth and leave for several hours.After all traces of softening can be easily removed.Laminate flooring is cleaned using the above-mentioned drug Dimexidum .

Finally, find out how to clean the mounting foam when it gets on the skin or hair.First of all, pay attention to the fact that under the influence of substances released by skin contamination itself will come in a few days.You can try to remove it with vegetable oil.Sometimes used means Reiniger .After contact with the foam on the hair a unique solution - to cut out the polluted strand.With her clothes, as a rule, can not be removed without a trace.You can try to use Dimexidum , but complete removal of stains probability is very low.