Accessories for grinders - How to simplify your task?

How to choose the drives?

Working part of the tool is a grinding wheel.This is the main and most important accessories for grinders, all the other accessories are designed either for specific operations or to facilitate the work of the operator.In each datasheet LBM indicates the maximum diameter of the circle, which is approved for use.It also indicates the thickness and diameter of the hole for installation.There are different types of disks for different purposes and needs:

• Grinding or cutting discs.With their help it is carried out cutting and grinding of workpieces.When the inclination angle is about 30-40 degrees.the following is not recommended to work with blanks and swaying with the broad sides of the materials used.If you choose to pay attention to the absence of any deformation, cracks, chips.The maximum number of revolutions of the disk should not be less than the rotational frequency of the tool.
• Belleville grinding wheels - they can be used to work with metal, wood, plastic and stone.
• cup grinding wheels are made from solid material.Used to work in small planes, clean layers on plastic.Also suitable for fitting panels of limestone and to remove old layers of paint.
• Diamond wheels.This is a special category, which represents for Bulgarians accessories.Each circle is only used for a certain material, such as granite wheels get stuck in with viscous material properties and asphalt blunted wheels when working with granite.

Important!Do not make deep cuts in one go, as this will reduce the period of the Bulgarian service, and the disc will be getting a huge load.

Extras

to improve and facilitate the work, there are various accessories for grinders.Especially often need a protractor, which allows light to cut sections (tiles, flooring, skirting boards and so on).For these purposes, you can use special tools, but they are often bulky and uncomfortable.Therefore protractor for angle grinders is a great alternative.

cut material falls on the guide area with a special anti-friction lining and into the slot rotary design element.The workpiece is firmly pressed his hand to the shelves angle exhibiting the desired angle of cut.Next, lightly pressing on the disc, the cutting profile begins.This protractor consists of only four parts: basic parts, lock parts, hinges and locking bolt-lamb.

Note!Protractor is suitable only for smaller profiles.

Another separate group of accessory parts for grinders.This electric tool, like any other, is experiencing great stress at work, as well as the strong influence of dust and dirt, so sooner or later the event of a breakdown.Many faults can be eliminated by replacing the damaged parts with new one.In aftermarket presents all the necessary items for this.

for Bulgarians with their hands tools

is often necessary to perform a particular job grinder, but keep it on the uncomfortable weight.For hands-free devices for used homemade grinders.Most often it is a simple frame of a conventional box.To make such a base frame with your hands, you need to make a wooden box.It is enough to make just one side for holding tools and the top of the frame.Instead, the rest of the walls just to attach the legs, it will save time and materials.

Protective casing is removed from the grinder.Worn drive on the tool leans against the side wall and marked where the gap has to be done to drive or travel tips.The gap is narrow, so that between the disc and the walls of the gap did not get extraneous tools.However, if you plan to change accessories without disassembling the structure, then the gap will have to make wider.two bars are mounted to the tool box to support the wall.This stand ready to work.

Important!Since the protective cover removed, it is necessary to operate only in the protective mask.