If creaking parquet, what to do master ?

reasons unpleasant creaking parquet

Constant creaking can be deduced from myself balanced person, so you should understand the reasons for its occurrence, and eliminate them.The main reasons are:

• uneven base;
• gapping sheets of plywood or hardboard to the cement base;
• wrong technology stacking board;
• parquet peeling from the base;
• lack of technical gaps;
• wrong choice of substrate and most wood flooring;
• humidity in the room.

The following recommendations tell us how to get rid of the creaking parquet and help prevent its occurrence.If the substrate is poor or uneven, then this will lead to delamination of the board and its destruction.Such a coating, laid on the basis of no intermediate layers such as plywood or chipboard, eventually will hang out and exfoliates.That is why the creaking parquet in this case.

Eliminate creaking parquet

screed repairs Before you remove the parquet creaking associated with uneven ground, it is necessary first of all to dismantle the cover completely.After dismantling should evaluate the condition of the cement base.If the coating cracks or start to break down, it is necessary to make a cement screed or self-leveling mixture before use plywood flooring.

ties roughness should not exceed one to two millimeters per meter of the surface, otherwise the parquet begins to creak and crumble.If the cause of the squeak of the floor is connected with the loose fit of plywood to the bottom, as is necessary to fill the screed again.

If creaking locally, eliminating the creaking parquet is carried out as follows: it is necessary to remove a few boards, find the problem area, drilled in the plywood sheet hole and pour it in cement.This will give a sheet of plywood and fiberboard additional support.It is necessary to fix the creaking at the first appearance, otherwise it will lead to the destruction of the board in the future.

are looking for problems in the design

often creaking parquet can be caused by poor geometry of the floorboard and the failure to technology its installation.To avoid this, when choosing a board should pay attention to the quality of its locking system.When mounting should riving each packed row.The optimum gap between the planks and the wall should be approximately 10 mm.

There is a high probability that the creaking occurs due to improper location of the log or defects.Before you remove the creaking parquet associated with this problem, you must completely remove the cover to check the integrity of the lag.

If you do not need to change them, then you should check the distance between them.Step between the joists must be approximately 30 cm. Also, using a spirit level or flat rail is to ensure that the whole system is a lag in the same plane.To enhance the rigidity can pull logs to the base with dowels.

Subject to all rules and regulations in the process of installation of parquet flooring still exists the risk of creaking underfoot.Maintaining optimal indoor humidity regime is a very important component of the proper operation of the parquet floor.

Giving or absorbing moisture, wood tends to shrink or expand, respectively, which can be a cause of squeaking.Optimal humidity in the room should be 50%.Do not wash the floor so wet and nevyzhatoy cloth, because the moisture will absorb floorboard locks, and all over the floor bumps are formed.