How is the grinding of parquet with his own hands

Sanding parquet with his own hands is not performed manually

agree to treat sandpaper dozen square meters - the work is very difficult, if not unbearable.That is why, even if what is done with his own hands parquet sanding (this is cheaper than hiring professionals), it is best to use special machines.They are divided into several types: drum, tape and disk.

drum and belt sanders treated parquet surface is quite rough, after they still remain superficial scratches, so it is advisable to use a universal units.If there is no finishing flooring can be sanded using a sinking circular grinding machines.The universal units provides various tips, through which you can perform any kind of work on the processing of parquet and floorboard.

Sanding parquet - a process that requires patience

So, the machine must you have, it remains only to determine how to use it.In general, control units for polishing the wooden floor is not particularly difficult, to master all the features, there is a guide.But exactly how to perform grinding of the parquet - we must know.Take the example of a tape machine, move with it along the premises should be slowly, pushing the car in front of him so that her right tire after the first number appeared on the polished surface.In other words, the driving of the room should be left to right.

Before you change direction is reversed, the drum should be raised slightly, it refers to any type of machine - so you will avoid damage parquet.Sometimes the strips can lie unevenly, there is a case that only the flooring is laid.In this case, before starting the processing of the surface, take test passes, lowering the drum set band, but with the engine switched off.If the lever, lowering the drum rises - hence, in this place there is a projection if more recessed - you find depression.Such areas should trace the chalk, to give them more attention.

When different heights parquet slats first pass is performed in the direction of the grain so that the surface is slightly flattened.

How to eliminate scratches on the floor

many types of flooring, and each requires an individual approach, it is impossible to polish floors with tiles of different species of the same pattern, it can severely damage the finish.For example, mosaic parquet should handle traffic at an angle of 45 degrees to the strips, not to get Grinding of.Scratches on the floor with riveting removed in two passes, the first carried out at an angle of 7 to 15 degrees to the slats, and for the second duty cycle is carried out fine grinding.

should be used consistently abrasives varying degrees of granularity With a strong jagged strips.For example, to remove deep scratches with a minimum of passes, first apply a coarse abrasive, too, to some extent leaving scratches, but removes more noticeable defects.Then undertakes a fine grain sanding paper, and so the cycle to cycle, to absolute smoothness of the surface. It should be remembered that the step difference in the grain shall not exceed one room. control grinding before to remove scratches from the parquet, is usually performed using numbers consumables K50 or K60.