Decorating the bathroom tiles room

in our lives bathroom plays an important role.It provides for the adoption of water treatments, laundry.In the bathroom, a person is resting, relaxing after a hard day.And sooner or later we will think about how to make this room look nice.So, it would require a tile surface finish. before finishing the walls and floor ceramic tiles surface preparation.Take off the old paint and tile, and then primed with a special acrylic primer or divorced PVA in water.Priming the walls should be done as follows.

Stages of finishing bathroom tile

For 5-30 minutes.before tiling walls plane need to be treated fairly thoroughly primed.Primers bind dust, make better glue adhesion to the surface.You can prime the walls of the strip width slightly more tiles: and the work will be more comfortable, and the sense primer plane is not lost.Blot can be a brush, you can paint roller.

recommended starting trim

first with the plane of the floor, asflat floor - the success of the mortgage.First, if it is uneven, filled with a special self-leveling screed, in shopping malls, it is sold in dry form.When the screed on the floor is dry, begin by lining the floor of the doorway to the entire undercut plitika was under the bathroom.During the work will have to be faced with this type of work as a tile trim.It is as follows: on the tile is applied to the cut line with a pencil, laid on plitkorez- device for cutting - and with little pressure on the tiles hold the line with a special knife, which is present on the machine.Make a change of heart - all cut tiles.Once the floor is laid the first row of tiles, check it on a level plane, the initial number - the most important.From it and go further lining the surface.Between the seams tiles inserted plastic crosses to the seam line was flat.

next step - after a dry floor tiles, begins facing wall surface : departing from the floor 10 cm to the wall, on a level fastened metal profile, for this applied the dowel-nails and drill with a percussion mechanism.The process of gluing the tiles to the wall does not differ from the floor lining, the only difference is that the work is going on a vertical.Strings tile can be ceaseless number.Starting also possible with any wall, although that usually is coated first wall, where the bath.Often begin to lay the tiles on the angle tile rests symmetrically, and if incorrectly calculate the thickness of the seams between the tiles, then add on the final number could be closer or larger than the first slaughter.

final stage - grouting : rubber spatula take longer prepared grout with water divorced.The density of the grout must be very liquid, but not very thick.Apply to tile joints so that the grout is fully seated in them.After 10 minutes, a damp sponge remove the remaining grout from the tile surface and gently smoothing the seams.All the process is finished tiling the bathroom of the room.Good luck!

Video finishing bathroom tile

For greater clarity, we suggest you familiarize yourself with a video option of finishing the bathroom.