How to cover up the cracks in the furnace

Autumn came, followed by a cold winter comes.Residents of private houses are beginning to heat the stove, and was surprised to see that the smoke, instead of quietly leave through the chimney, gets into the living room.In order not to speculate than to cover up the cracks in the oven, they are invited to the stove-fitter.The visitor wizard explains that the problem seriously, and no telling how to cover up the stove to avoid cracks, puts plump account that scares its size.To not have to pay unreasonably high bills, do not wait for the masters in a cold house, you need to understand yourself, what you can paint over the stove.

Reasons furnace smoke

The reasons that smoke does not go through the chimney and is spreading around the house, can be varied.The most common of them - is clogged with soot chimney.By eliminating soot, heating quickly adjusted and the problems no longer occur.

If the house for a long time no one lived, the putty is not required for the furnace.Infusion of the chimney starts to not work, but the fault is corrected easily.It is enough to warm up the riser, burning paper, and the smoke goes to the correct path.

If you do not know whether the stove is used to work, the failures in its operation can be caused by irregular masonry chimney or clogged channels pieces of bricks.In this case, can not do without a major overhaul.

Well, and, of course, the crack in the chimney or the furnace itself lead to a breach of its work and the appearance of smoke in the accommodation.

The gloss over the oven, so as not cracked?

cracks in the stove - is inevitable, but to eliminate the minor problems in the state of any man.

most common cracks that appear on a radiator - a spider web.The network, which are small non-through cracks, which detracts from the appearance.They need to be removed, because they gradually will cover a large surface area.

Before obdelat stove in the house, you need to clean the damaged area of ​​quality, knock plots chisel formation of cracks.The cleaned surface should be clean brushed metal.After that, purified of the wetted primer.When the primer dries, place peeled plaster with a mixture of clay and sand.

cracks occur often in places where the elements are mounted stove, for example, the furnace door or ash.Before smear the stove, so as not to crack, in which case you must first remove the door completely, efficiently clean up the destroyed place, only then you can start the restoration work.

Before gloss over the stove, you need a door frame to fix the wire so that it does not fall in the future.On the perimeter of the door need to put asbestos cord, and all other work to perform in the same way as in the elimination of spiderweb cracks.

to seal cracks in the brickwork of the furnace, it is necessary to begin to clear the problem joints (slightly deepen and expand), hereinafter referred to drench with water, and then cover up the thick solution from chamotte clay.

To better understand how to cover up the oven to avoid cracked, be sure to watch the video at the bottom of the page.

Video plugging cracks in the furnace