Woodshed with their hands

Quality woodshed allows accurate and properly stored firewood and stoves.It can be manufactured inexpensively.To work required slats, plywood, film, soft roof, hinges, screws.Also required black and white paint on wood.The size of the considered woodshed - 164h164 cm, which can accommodate approximately 4.5 m3 of wood.

assembly side andrear walls

Collect woodshed with his hands is simple with the right sidewall and roof.The side portions have the same frames.Bottom and left / right rails are perpendicular.Upper limit is beveled.This design is perfect for the creation of an unusual roof, which will take deposits.

between the left and right rail (in the center) requires a jumper to harden the final component.Reiki are connected with screws 5h100 mm.

Additionally corners on the inside reinforced with perforated metal plates.

second sidewall is made similarly, but the bevel strips she should be reversed (not from left to right and vice versa).The rear wall is a mirror image of the side.Get 3 frame.

Preparation upper blocks, floor and roof

upper part of the side and rear walls - a wedge, echoing the shape of the prepared frame.It is necessary to cut four identical parts made of plywood, as shown in the accompanying photos.

Then the items 2,2h45 mm nails to nail to three frames.

We stayed another wedge out of plywood.It is attached to the four frame which must be made of strips with self-tapping screws, and then fasten the metal plates.The shape and dimensions of this frame will correspond to the wedge.The frame itself is stationed above the door in the woodshed.Thus, the anchoring wedge with nails to the last frame.

get 3 identical frames and 1 frame, which will be located above the door.

harvested door frame, side, rear panel painted with black paint, the rack (for the styling design) painted with white paint.But to understand how to build a woodshed, well protected against moisture, you must first examine the features of the ink composition.Typically, wood is first treated with an antiseptic, and then applied the paint 2-3 layers.

On the wall stuffed white slats.

also of rails, painted white, izgotovlavlivayutsya woodshed door.

plywood harvested two triangles, which will become the roof.In drawing they should represent a square with a side equal to the length of the top of the wall.Both parts are painted black on one side.

of thin, but wide board going whipped slatted floor.To the lower side of the floor, which will continue to abut against the ground, stuffed film for protecting wood from moisture.At this stage, all the elements ready design.

now learn how to make their own hands woodshed, help the instructions below to assemble the structure.

design Assembling

Completion woodshed occurs by assembling previously harvested parts.

install precast wall should support in the form of cones.Wedges are located near each corner shot down by gender (necessary to put them on a level).

Next to the side walls on both sides of the boards are attached

walls installed in the metal supports.

rear wall located between and fixed to the existing supports in the timber.

Small temporary straps are attached to the side walls as supports to make it easier to fasten trapezoid frame (to be placed over the door);

then cut off protruding parts of the boards, which will interfere with the installation of the roof woodshed.

Two of the roof fastened hinges.

roof is transferred to the frame (painted side and inside loops) and secured the perimeter.

Mounted on the door hinges, screwed internal vertical strip (for tight abutment flaps).

valves are installed on the doors.

installed on the roof shingles, coating residues are cut, skates covered with protective transitions.

Using the above instructions, will not be difficult to build a stylish and practical woodshed in the country or near a private house.

Help in this and the accompanying photos, and helpful videos.Before performing it recommended to make an accurate drawing, according to which the work will be done.

Video woodshed building in the country with their own hands