Slopes of plasterboard on the window can make one with their own hands - a description and tips

Did you know that the slopes on the windows give the dwelling is not only attractive, but also are part of the overall health of all premises.They create some room insulation as sound and heat.They are made of different materials, and most of all - the industrial way.However, the use of drywall and allows you to make and install the slopes with their own hands for 3 - 4 hours, even if you do not have professional skills.

It should be noted that only a special, water-resistant material is used for the job.Any other drywall bet no sense.Drywall - building material, which is perfectly cut, so you need to prepare in advance a well-sharpened knife (preferably building).Drywall Installation is carried out in two ways: directly on the wall (adhesion), and the profile that is installed on the slopes of the place of installation.

This method is somewhat more complicated, but with this method of installation of slopes do not have to align the wall, and do the slopes will be laid and spliced ​​smoother.Plus, the short distance between the wall and the resulting gypsum board, serves as a good air cushion, retaining heat in the room.Let's speak about the lighter, the first method.

Preparing to install slopes

First you need to carefully remove all the sizes.Preparing sheets of drywall for the slopes, you should leave a small allowance in value.Perfectly smooth surface of the installation locations can not be achieved, so it's better to cut off the excess.Worse, if later it turns out that somewhere "a little" is not enough, and it happens often.Before performing any work on the surface it is necessary to pre-prepare, and whatever way is not established slopes, a layer of plaster must be removed.

Wall should be well leveled using plaster, mortar, plaster - at the discretion of the master.After that you need to treat the surface by means of insects, fungus, since then these places free access will be gone.After that the surface is thoroughly primed, if necessary, that such an operation is carried out twice.Then begins the installation directly slopes.The adhesive must be a little thick - and this will ensure prompt pasting sheets and reliable coupling with the drywall surface.

Installation and gluing sheets of drywall

should start with the installation of the upper slope - he will be a "guide" for proper installation of the slopes on the sides of the window.After applying the glue on the upper slope of the workpiece it is necessary to accurately put the desired location and press.Then it needs to be fixed in a horizontal struts that are prepared to start work, and only after a reliable gluing work continues.

installation of side sheets produced using the same technology, keeping accuracy.Make sure that the seam turned flat - it will show that the blank set at an angle.Checking is also using a plumb or level.The joints between the white slopes are sealed with sealant or a special reinforced tape.Top on the edges of the sheets stacked plastic corners, which are sold in any store building materials.

After the installation of the work begins "clearance" slopes.Their surface is covered with a special filler which must dry thoroughly.After that it overlaps the second layer.There is the so-called finishing putty that and put the last layer.When all the "design" completely dry, slope surface is treated with an abrasive material until it becomes smooth.And at the end of the slopes are painted with white paint.

And only after that you can continue the execution of works.Finishing drywall sheets to produce better on the second day.More slopes manufacturing process can be seen in the video: