Choosing and correctly using tile adhesive for swimming pools

glue for swimming pools - especially

Product Use tile adhesive for tiling different structures with high humidity due to the fact that it has water resistance, high adhesion, elasticity and frost resistance.Also, its composition is resistant to chlorine and other substances that are used for water purification and disinfection.

So, choosing the adhesive, make sure that it is water resistant, has good resistance to chlorinated water and good adhesion.We recommend to use glue reliable suppliers and especially not to save on quality.

But not only in the quality and characteristics of the purchased structure lies the secret of a good lining.With the adhesive properties and special treatment required specific.In fact, you need to learn a few rules.

Tile glue for swimming pools - proper preparation

First you need to prepare the ground under the tiles, it must be firm, be sure to smooth, well-cleaned of dirt, paint residues, grease, oils, and, of course, from the dust.

After removal of dust and other contaminants should be sanding the surface, to remove all the crumbling layer and large bumps.If the surface is painted, it is necessary to completely remove all paint.If work is carried out outdoors, surfaces prepared to work, to be protected from the rain or snow (of precipitation).

After the surface has been prepared, it is possible to start the preparation of the solution.To this dry mixture should fill in pre-measured amount of water, water should be at room temperature, for about 1 kilogram of mixture to 200-250 milliliters of water.

The mixture is mixed thoroughly until a homogeneous mass is obtained, it will take about two or three minutes, if you use electric stirrer, and an electric drill with a designed for this purpose nozzles.

The following is a solution to stand for about 5-10 minutes and stir again all.The mixture must not be more than 3 hours during which time it is necessary to have time to use, otherwise it will come into disrepair.

Glue for tiles in the pool - sound operation

Tile glue for swimming pools should be applied to the base, using a smooth spatula and handle a notched trowel.Depending on the size of the tile size of spatula teeth selected.

tiles are laid within 15-20 minutes after applying the adhesive, rotational motions of pushing it into the adhesive.It is important to apply the solution onto the area to be covered with tiles in ten minutes to avoid drying of the solution.The works can be carried out at temperatures from +5 and +30 ° C.

Clay tiles dry for a day, but to fully grasp three days.Seams should be floated as no earlier than one day after work.They need to be cleaned even during tiling.Do not forget to stir the mixture solution continuously during the works.Never add water to a ready solution of glue.

Glue for tiles in the pool is consumed, depending on the topography, which will serve as a base for laying tiles as well as on the size of the teeth on the spatula and, of course, from the tiles.Average fuel consumption is about 2-4 kilograms per square meter, with a layer thickness in millimeters.

Observe precautions when working with glue.Do not let the solution get into the eyes, if this happens, immediately rinse them with plenty of water.Use rubber gloves when handling.

Typically, such adhesive is supplied in bags of 25 kg.Keep it should be in a room with low humidity.When the integrity of the packaging glue is stored exactly one year from the date of manufacture.