Adjusting the cabinet compartment door

cabinet compartment - a great element of the interior of any room, in addition, multi-functional.

It takes up little space compared with standard cabinets, while its capacity is much higher.

only minus any closet coupe - it's his door, which will eventually be regulated.

How can adjust the cabinet door coupe?

Immediately it is worth noting that the door conditionally divided into two types - roller and rail.More reliable, nevertheless, considered roller, but they have several drawbacks.

For more information about the hardware sliding door wardrobes can be found in this article.

Getting adjusted

door so to adjust the door vertically, get near the bottom of the door (where the moving mechanisms are placed) bracket bolt.

If it rotates counter-clockwise - the door will rise (approximately one turn of the bolt on the lift door 1 millimeter).And vice versa - if you turn the screw for clockwise - the door will be omitted.

If after closing the closet door is not pressed against the frame, the further you have to adjust the horizontal course of the door.

next to the first bracket get the second (he is often placed at the bottom or in the middle of a vertical side wall).

Similarly twist bolt and adjust the course of the door.Always after the procedure, check whether the opening-closing cabinet is normal, there is not anywhere else will fasten and so on.

Features Some models

perform further adjustments cabinet compartment door In some models.For example, a cabinet "STERKH" still present in the middle of the sealing frame, on which the gate lock is located.

There is also a bracket, which regulates the course of the door back and forth.

Sometimes there are cases where adjustments are made fully rails.That is, to select the height necessary to clamp and rail.

True, such a model cabinets are no longer available, so they are unlikely to meet you.

Video:

notes

And do not forget to place the door is also affected by wear and tear of the moving mechanism.At least twice a year to fully sort out the rollers, lubricate them with lubricating oil or grease mechanical.

Otherwise - the mechanism fails.And it is very difficult to replace, as spare parts rather hard to find.

To be sure that the adjustment has been performed correctly, just try to see if the door reeling back and forth.

If there is the slightest gap, which was not to adjust, then look for his mistake and continue the mechanism of regulation.