How to make a fence with their hands .Step by step instructions with photos

fence with their hands.Photo

wide range of materials used today for the erection of fences, give complete freedom of creative thought and imagination fly.A master classes with turn-based fence manufacturing instructions allow even beginners to build their own fence for your home or land.In this article you will find all information on how to make the fence with their hands.

fence made of stone with their hands

One of the most popular materials for the construction of the stone remains of the fence.In terms of reliability and durability of the stone is far superior to other materials for the construction of fences.From time immemorial preserved and come down to us is reinforced masonry structures.How to build a fence made of stone with their hands?

Construction stages

whole process of the construction of a stone wall consists of the following stages:

1. Planning and marking
2. Laying the foundation
3. erection of pillars
4. Masonry

Planning

First of all, create a preliminary drawing, with exact indication of height and length of the structure, as well as the location of the gate and the gate symbol.

fence made of stone with their hands.Photo

Layout

note the section of the border, which will be surrounded by a fence, by driving in the corners pegs .Between them stretch the cord and in places where the drawing provides an arrangement of pillars, to drive additional stakes.The distance between the support pillars should not exceed 2.5 m.

Foundation

Guided make a layout, proceed to dig a trench foundation.Taut thread allows to receive smooth lines while digging.Stone fence - heavy construction, requiring a thorough foundation , in order to avoid sagging in the future.The trench dug to a depth of 60 -. 70 cm, however, if the fence height exceeds 2 m, then with each additional meter height of the foundation depth is increased by 10 cm in width, depends on the size of the stone, but on average it does not exceed 40 cm

..

Before pouring the foundation to the bottom of the trench lay a bed of sand or rubble .Good rammed it and begin to strengthen the foundations of the middle section of the valve.We spread the waterproofing layer of tar paper, set the formwork and, finally, begin to fill.Depending on the type of concrete, the foundation will seize and acquire necessary hardness within 15 - 30 days.In cold weather, it takes more time to pour.In hot weather, moisture is lost, which is required for hardening processes.Therefore, the summer should hide after pouring the foundation thick tarpaulin regularly to moisturize it.

erection of pillars

After hardening bases proceed to the construction of pillars.To build a fence made of stone with their hands, you must select the appropriate material.With a lack of experience in masonry pillars recommended spread of hewn stone, with smooth edges.Quarry stone spread more complicated, but it allows you to create a unique design of the structure.

Installing formwork for the lower layer and lay it flat stones side out, trying to accommodate them as much as possible close to each other.The thick mixture of cement fill in the gaps between the stones.In case of contact on the surface of the stone, clean it with a wire brush until completely dry and free of water.Similarly spread all subsequent rows.

masonry spans

Placing flown is carried out on the same technology as the erection of pillars.To give the aesthetic appearance added to the mixture of dry dye.Upon completion of works narrow spatula perform grouting.

fence made of stone with their hands.Photo

fence made of bricks with their hands

Brick fence - this is not just a reliable guard of your home.Due to its aesthetic qualities, brick buildings look stylish and concisely.A correct geometrical shape of the material allows even a novice to build a fence made of bricks with their hands.

Since brick - not a cheap pleasure, an important step in building a estimation required materials.The number of bricks is calculated based on the following parameters:

• wall thickness (in one or two bricks);
• height;
• fence length.

following stages of work:

1. Layout
2. device foundation
3. Erection of brick pillars

fence made of bricks with their hands.Photo instruction

After marking and designation of places poles begin to dig trenches and drilling recesses for the vertical supports.The depth of the trench - 40 - 45 cm, taking into account the thickness of the buffer layer of sand or gravel, hole depth - 1.5 m diameter must be greater than the diameter of the metal support section 15 -.. 20 cm pillars set into the prepared cavity.

After complete drying of concrete (20 - 30 days), proceed to the construction of the brick pillars for lining by vertical supports.The simplest type of masonry - is putting some 4 elements around the post.Bricks lodges atsya on a cement mixture, which is tight compaction is achieved by tapping on the brick.Options for laying a lot: in the photo are some of them.Follow the steps below fence manufacturing of bricks, presented in the video, you can build a beautiful and sturdy fence for the house, without the need for costly professional services.

fence of corrugated board with his hands

If you need to quickly, safely and at no extra cost to protect the area from prying eyes, the best solution is a fence of corrugated.This material has several advantages:

• of corrugated fences are durable and robust;
• are resistant to adverse environmental factors;
• have good sound insulation;
• not require special care;
• successfully fit into any surroundings;
• affordable;
• installation of a fence made of profiled sheet does not require special training.

fence of corrugated board with their own hands.Photo

Profiled is a great option for garden fencing, or suburban area.Use the following instructions photo fence construction in the country, you can easily build a fence.

Construction stages

1. Planning and marking
2. Installing the vertical supports
3. device horizontal lag
4. Installation sheeting

Planning and marking

To mount the fence of corrugated board with your hands, you can do without drawing.It is enough to measure the portion of the perimeter, to determine the place where they will be gateway and make markup , marking the corners with pegs and place vertical supports, the distance between them should not exceed 3 m. Location gate is left free.

Installing racks

in certain places swarm of deepening the depth of which should be equal to 1/3 of the height of the rack.The diameter must be greater than the diameter of the cross section of the rack for 15 - 20 cm can be used as a round tube and square section..Install support vertically using level.Fall asleep to the bottom of the pit layer of sand or gravel and fill with concrete.

device horizontal lag

After 3 - 4 days, after complete drying of the concrete, to the uprights transverse welds logs at the rate of one lag for each meter of the fence height.

fence of corrugated board.Step by step photos

Mounting trapezoidal sheet

Finally, the finished frame fasten sheets of corrugated board, setting them overlap, overlapping one another on the same wavelength depth.Fasten with screws or rivets in increments of 50 cm. The scratches formed in the process, paint over paint from a container or cover the primer to prevent corrosion.

fence slabs with their hands

supporters ekostilya like fence of slab, which is not only original, but also cost-effective solution in the construction of the fence. Slab - this residual cheap timber, which is formed by the longitudinal sawing logs.One of its surface is smooth, and the other - with the remains of a convex crust.The higher knotty surface, the lower cost of the material.

Slab - excellent material for the construction of the fence to the wooden country house.Photo guide the construction of the fence in the country will help to build a fence, even a person, far from the intricacies of building skill.

Construction stages

1. Planning and marking
2. Installation uprights
3. Install Cross Bar
4. Fastening slabs

Planning and marking

to build a fence slabs with their hands, around the perimeter of stretch the string andit denotes the place vertical poles in increments of 2 - 2.5 m.

Installation supports

digs holes for the vertical supports on the depth of soil freezing (1 - 1.5 m).As supports can be used as a metal pipe, and wooden poles.In the latter case, the poles should be prosmolit hot tar or varnish on high, were placed in the ground.With rack-level set vertically and pour concrete.

Install Cross Bar

cross bars are not always necessary.The need for them appears only in the case if the slabs strips are mounted vertically.For horizontal mounting as they can be fixed directly to the vertical supports.

Fastening slabs

slab laying method depends only on your imagination.Rods can be placed overlap or gap, either vertically or horizontally.When laying the overlapping strips must find each other by less than 2 cm, as should be expected shrinkage of 1.5 cm. With a vertical arrangement of the upper edge slats can be flat or shaped.

few tips

Extend the life of the fence of slab to follow these guidelines:

1. Do not use too wide boards: they will crack over time, which will worsen the strength and appearance of the fence.
2. Ready fence should be covered with paint or varnish: so you can not just give it a more aesthetic appearance, but also to create a barrier to decay.
3. Install gable roof over the fence: it will emphasize the retro style and protect your fence from moisture.

Fence made of bamboo with his hands

There was a desire to allocate a portion of the general background of dull fences?Then the fence of bamboo - this is what you need.This exotic plant will give your architectural ensemble a touch of originality.Bamboo Fence will look stylish and interesting.How to make a fence with their hands?Our photo guide will help you to easily cope with the task.

Stages of

1. marking territory
2. Installing the vertical supports
3. wooden frame Production
4. Collection shield made of bamboo wood-based
5. Fixing bamboo panels to the posts

Layout

No matter from whatmaterial construction fence, the work always begins with marking territory and designate places for the vertical supports.To build a fence of bamboo with his own hands, in the wooden poles are used as supports.

Installing the vertical supports

The marked areas are dug grooves on the third pole height.To prevent the process of decay wood prosmalivaem or mastic asphalt cover that part of the column, which will be in the ground.Install support vertically, using this level or plumb.Pour the bottom of the pit layer of sand or gravel and pour the cement mixture.Leave for 3 - 4 days before the concrete has set.

Prepare wooden frame

metal nailed to a pole embedded parts, which will be held wooden frame.Details on adjacent poles must be on the same level.To achieve this, we use the board and the level.

horizontal planks cut off the desired length and insert them into the inserts on the pillars.Then proceed to the installation of vertical x boards.Fasten them with screws to the horizontal boards with a pitch of not more than 1 m.

collect bamboo shield

The finished wooden frame shooting with vertical supports and placed on the box.In the corners of the frame is screwed screws in order to prevent rolling bamboo trunks from the base.We begin to stack on bamboo frame trunks tightly fitting each other.Self-tapping screws attach the bamboo to the base.With wide board note the desired height of the bamboo board circular saw and cut off all unnecessary.The same is done on the other end.Our bamboo shield ready.

Putting a fence

Ready fence is installed in the holding parts on poles and attached by means of screws.Attachment points camouflage bamboo trunks.To prevent the ingress of rain water into the trunk, the upper edge of the fence should be laid boards, which are attached to the uprights with screws.To prolong the life of the fence, bamboo and all the wooden part of the treated primer antiseptic and cover with water resistant varnish.

Wicker fence with their hands

If you are tired of dull concrete and iron fences, and then catches the eye, fence your site easy braided construction, which will give the exterior of yourhouse or villa lightness and pastoral atmosphere.To build a braided fence in the country with their own hands is a snap.It takes inspiration and a little patience.So, what are we for this useful?

In order to make a braided fence with his hands, should pay attention to the choice of wood.The rods must be thin, compliant, but at the same time strong.