Replacing a toilet bowl with his hands

Sooner or later there comes a time when the old toilet in the apartment becomes unfit for use, and it is necessary to change a new one.Most often, the average tenant replacement toilet may seem expensive, if there is a challenge to plumbing.However, armed with a certain set of tools and apply some skill, you can replace the toilet on their own, and the recommendations below will help to carry out this process efficiently and cost-effectively.

The first step is to decide whether it will be a complete replacement unit or, say, the partial replacement of the toilet cistern.In the first case, should start by selecting a new model toilet bowl, namely with the selection unit suitable size and configuration.As well as the old toilet, the new device should provide users with comfort in mind, so just before the replacement and installation of a toilet is necessary to make measurements of the toilet, and already considering these parameters to choose the model that will fit into the space properly.Namely:

Note that when replacing the toilet in the apartment some models due to the characteristics of attachment has shifted significantly forward.

In the event that only requires replacement of a tank of the toilet, the whole set (toilet plus tank) to acquire becomes impractical.Anyway, any plumbing shop can offer flushing cisterns any configuration: built-in wall-mounted shelf toilet, as well as installed under the ceiling.Choose from the range presented is based on the features of the room and your own preferences.

now directly replacing old toilet.The whole process begins with the dismantling of the old unit.If we are talking about replacing a relatively new device, connected to the sewer system of plastic pipes, any problems should arise here.And if, for example, be replaced Khrushchev in the toilet, there is much more complicated.

In this case, you may experience a variety of difficulties.Thus, the dismantling of the tank can be complicated by the poor condition of fastening elements.During the long years of service fastening bolts rust, it complicates the process of their removal.When dismantling of the toilet, as a rule, there are similar problems with the fasteners, as well as difficulties in removing the issue from the cast-iron sewer.In those years, these connections are made by sealing a tow, followed by sealing of grout.Of course, the decoupling of such compounds - a very laborious process.

When replacing your old toilet with a new no need to maintain the integrity of the old unit, the old toilet, you can simply hammer to break into several pieces.Removing the toilet only a qualified professional can perform while maintaining its integrity.After all fasteners are disconnected, the most difficult task - to remove the issue from the sewer pipe - overcome, you can proceed to the installation of the new toilet.

As a rule, the entire sequence of the installation of the new unit is described in the attached instructions and videos replace a toilet, represented on the site, even more clarifies the mounting pattern, so focus only on the key points.

So, replacing the toilet with his hands on the new device installation phase includes the following steps.

neck iron sewer carefully trimmed on it with silicone sealant is fixed and a rubber cuff connected gofroshlang.

new toilet is placed on the floor, outlines its contours and attachment points.Drill holes for fixing the toilet installed and secured with special powerful bolts.

toilet tank after assembly is attached to the internal drain to the toilet, this is also used special bolts and sealing rings.

The final step is to connect the device to the water supply and sewerage systems.

Thus, these things short guide with photos on how to replace a toilet will help you not only to produce the entire range of activities on their own, but also to save on plumbing services, as well as to accumulate invaluable experience in plumbing replaced.

Video replace the toilet with his hands