How to hang wallpaper with the selection of the picture with his own hands

Wallpaper - this is a popular material for finishing the ceiling and walls.A wide range allows you to choose the wallpaper to your liking, taking into account the interior premises.After selecting a suitable material for many newcomers there is one question: "How right wallpaper paste with the selection of the picture?"Learn more all the details of this workflow.

As wallpaper glue on the wall with his hands

Let's start with the basic rules of wallpapering.To work looked most carefully, you should try and prepare everything.

So, for we need these materials and tools:

• wallpaper;
• glue;
• rubber roller for rolling joints;
• ladder (if gathered hang wallpaper on the ceiling);
• plummet;
• pencil and ruler;
• stationery sharp knife;
• spatula;
• roller for glue;
• container for glue;
• cloth to remove the excess glue.

Now we need to prepare the surface.If you bought an apartment in a new building or a newly built house, the walls are likely to be porous, so it is necessary to cover them with a primer mixture.Do not forget to pause and wait for the dry wall.Now you're ready to go.

Another question, if there is paint on the walls or old wallpaper.Then you need to clean off the paint first, then treat the surface of a special tool, and then rinse with water means.Wait, when the wall is dry, apply a coat of primer to.If the walls are covered with glossy paint, you have to try to clean off the paint.Arm construction hairdryer, use a stiff brush or abrasive paper.

Remove the old wallpaper off the wall just enough to pry the edge of the wallpaper spatula and pull.If the old cover is difficult to remove from the surface, while on the walls smeared with a special solution (sold in DIY stores), maintained a certain time and then you can proceed to the preparation of the walls.Or you can do this: moisten with hot water areas where the wallpaper tightly glued, and then carefully remove the wallpaper from the wall, armed with a narrow spatula.Work carefully to avoid damaging the surface.

By the way, those areas where there are swings, chips and cracks, it is necessary to putty.It separates the main point - pasting wallpaper, but the end result will please and wallpaper will be a long time to stay on the walls.Do not forget, after finished to putty areas dry out, clean up these places sanded.Before you begin pasting wallpaper walls, make sure that the surface is smooth, clean and dry.

Preparatory points:

1. Lay all rolls of wallpaper, designed for sticking one room.You need to compare each roll to the drawing color is different.
2. Now you can prepare the adhesive.Adhesive sold in dry form and must be prepared independently.Knead the adhesive according to the rules (as instructed) and wait until it becomes homogeneous.
3. Getting wallpapering.To do this, you need to arm themselves with building meter and measure the length of the wall (do not consider the plinth).
4. Next we need to expand the roll of wallpaper and measure the length of the paper, plus a 7-10 cm reserve for the stock (it is certainly better then cut the excess, than dokleivat wallpaper strip).
5. otcherchivaem now on the wallpaper using a pencil and a ruler line (you can just wrap paper) and cut with a sharp knife strip.
6. If you choose wallpaper without pattern, then you can immediately prepare several bands, not to be distracted and to start the process of pasting wallpaper.If you purchased your wallpaper with a pattern, then it will have to spend more time to prepare.First, cut off the first strip of wallpaper from the beginning of the roll, then unwinding the second roll of wallpaper and select image combining fabric as long as no pattern match.Once you prepare a few bars, you can start wallpapering.
7. Not everyone knows that you need to begin to hang wallpaper with the lightest area of ​​the room - that is, away from the window.We continue the process of sticking the next band counterclockwise.The last strip is pasted in the window, but from the opposite side.

Terms cutting wallpaper

Consider all the options, so you do not look for answers to the questions:

1. cut out the wallpaper without pattern - if the maximum wall height of 2 m 65 cm, then we need to cut strips at 66-67 m 2see, to leave a small margin.Roll out the roll of wallpaper and cut strips of desired length on the front side.The following bands are cut off from the same roll.
2. Cutting wallpaper with the selection of the picture without bias strips.These wallpapers cut out a little harder.For example, if your ceiling height is 2 m 67 cm, then you must first determine the step of drawing on the canvas.We need to cut all the bands start with the same pattern.We select the first one strip, and then to her one more to match up the picture, but from a new roll.Further work with two rolls.The residue from each band should be minimal, since the pattern on the paper web and remove small strips do not have to.
3. is not the case with the wallpaper on which to combine the pattern or a large drawing.If you cut off a strip of desired length, it is possible to detect that the next band was not suitable, so you need to retreat a step to combine both bands.two rolls of wallpaper can be designated for convenience: №1 - the first roll, №2 - second.Getting Started with the first roll, then cut the stickers starting stripe next strip from the new roll (№2), customize a drawing (less waste).It is more convenient to operate and combine drawing.It can be on the wall, so as not to get confused, to designate the strip with a pencil.

How to hang wallpaper with the selection pattern

can apply wallpaper, not calculating anything, that is - to simplify your task.Just open a new roll of wallpaper, unwinding strip, measure the correct length and stick it on the wall (or ceiling).Then we look at the drawing and select it started unwinding a roll of wallpaper.So work can be faster, but the wallpaper flow will be too great.Can you imagine, with each roll, you will have to stay at 1.5 m unnecessary wallpaper.Why such a high consumption of finishing material?

can act differently and try to pick up a pattern is not in place, and on the floor.To this end, both the roll and unwound select pattern, shifting to one of the strips until the pattern does not match.Method acceptable, but do not forget about the mirror image pattern (applies to not only the ceilings but also the walls).It is important to introduce pattern on a wall or ceiling in a finished form, where he begins and it will turn out beautifully.

pattern matching techniques described herein for pasting wallpaper suitable for all types of paper wallpaper, vinyl and non-woven basis.

Sticking non-woven wallpaper with your hands

Non-woven wallpaper - a modern material for the walls, which has a high degree of wear resistance.Sold in rolls of wallpaper, a width of 1 m. Hang them very convenient as it is not necessary to pre-prepare the wall.Small bumps on the pasted surface will smooth the thick non-woven wallpaper.

We'll hang wallpaper with your hands joint to joint, prepare for the start of the strip of wallpaper to the entire room.Because we need to stitch pattern, then our task is a bit more complicated.Before you begin cutting strips, measure the height of the walls in several places (ideally - every 30-40 cm).If there are no differences, it is possible to start cutting the desired length of wallpaper.

you bought the wallpaper with a large pattern?Then you need to come to the cutting process very seriously.Look at the label: the manufacturer specifies the size of a drawing fit.To combine the pattern, you need to immediately open 2 rolls of wallpaper and move the first workpiece next band (or measure the distance indicated on the label).Be careful and then you do not have dokleivat wallpaper below (if you do not have enough length of the strip or you incorrectly combined fabric on the figure).

There are certain rules that should be followed: if the ceiling height is standard - 2.5 m, the strip length should be with a margin - 2.88 m, then fit the size will be 48 cm

Strips can be cut directly on the floor (prepare a place in advance or.lay on the floor dense polyethylene).Roll out the roll of wallpaper face up to combine drawing and cut the strip equal to 2 m 88 cm (there is already a stock).Bend the strip so as to match fabric and cut with a sharp knife along the fold line wallpaper.We've got the front page.Now you need to deploy a new roll of wallpaper and combine drawing.Do not rush to cut the second strip, waste away, to assess visually correct alignment.Everything is fine?You can cut the strip and start wallpapering.

need to roll to roll on one side only, then it is possible to do several pieces.

Irregularities of the Non-woven wallpaper is that the glue does not need to be applied to the wallpaper, only the wall.Armed with a roller, evenly distributed layer of glue on the surface of a wall, grabbing a little more than 1 m to the joints well glued wallpaper.

After bonding the first strip of wallpaper residue can be cut with a sharp knife.Try to perform this work as carefully as possible.

As wallpaper glue to the selection of the picture.Video:

Sticking vinyl wallpaper with your hands

Gluing vinyl wallpaper should be exactly the same as the non-woven.The only difference - the basis of vinyl wallpaper is thinner than that of non-woven wallpaper, so you need to pay more attention to the preparation of the walls.

Subtleties workflow:

• make measurements of the room and cut into strips of wallpaper, the walls of equal length plus a margin of 7-10 cm;
• prepare glue (for vinyl wallpaper to buy special glue);
• foam roller smear glue on the ceiling / wall, and thoroughly coat with the severed strip of wallpaper;
• waiting for the glue is absorbed;
• armed with a spirit level, make pencil marks on the wall, so as not to go over the line and stick exactly lane;
• glue strip to the wall, a good iron blade to release the air.Extends over the entire web surface glued rubber roller to expel air from the middle towards the edges from the middle of the up and down;
• next strip is pasted in a similar manner, joint to joint;
• if you were quick and pasted canvas, and then noticed that formed under the wallpaper air bubbles, you need to walk through this place with a rubber roller.If it does not help, then it is necessary to pierce place swelling needle, and then to inject a bit of glue (type in the syringe).Will only smooth out the surface and see to it that the wallpaper is well glued.

wallpaper What is easiest to glue?On this question, you will not find a definite answer, many masters stop at choosing the non-woven wallpaper, some like the Soviet version - simple paper, but there are people who want to add flavor and to allocate a separate section and stick other wallpaper.For example, the wallpaper adhesive on the basis of, or wallpapers.

With the help of photo wallpapers you can decorate any room.Due to the fact that on the opposite side of the web is applied adhesive composition, to work with such material is a pleasure.No need to pre-cook the glue and messing around with brushes and rollers, add flavor to the interior space can be just a few hours.

wallpaper adhesive on the basis can be of different sizes, plain and patterned.To combine the pattern on the wall, you need to be very attentive and careful, because if you disconnect the protective film and glue fabric to the wall, and then discover that the picture is not aligned, peel strip there will be very difficult.

This type of finishing material has a lot of advantages: strength, huge selection, ease of gluing.You can change the interior in the nursery or bedroom every six months.

As wallpaper glue your hands you can learn from this video: