Clean well with your hands : the instruction , causes of pollution

Well, like an oasis in the desert - it is the source of life on a country site.It is no secret that a well device - a laborious process and its construction will require a small team, working with the simplest tools.This scrap, sledgehammer, shovel, rope, bucket.Modern wells are satisfied with the help of RC rings, sags under its own weight into the prepared slaughter.Bottom fed a bucket of soil, allowing the future to deepen the well.The number of concrete rings depends on the depth of the well, or rather, from the depth of the aquifer.

Before developing the mine is measured by the external diameter of the rings, the diameter of the well is slightly wider for optimum slip RC products.With proper selection of the diameter of the well, the ring slide down vertically, aligning all the shortcomings of hand-held device.Many of the well when the device uses a plumb line.The use of at their summer cottage lifting equipment is not often possible, so in the case of loose soil is necessary to omit the ring manually.When you start the aquifer, it is necessary to seal the lower joints of concrete rings to drinking water quality is consistent.Sealant is a cement-sand mortar.Height aquifer usually reaches two rings.To a large extent it depends on the soil type, which is arranged well, the degree of filtering.

Cleaning your hands well

Causes of water pollution in the well

on water quality in the well depends on whether you can drink it raw.That is why you need to take care of timely cleaning.Why is water in the well is polluted?This is for many reasons:

• 1. In a well hit the biological element from the external environment.It can be anything - a plant or an amphibian.It should be immediately disinfected water from products razlozheniya.2.Tonky bottom layer filter provokes the appearance of sludge.The water becomes cloudy and there is an unpleasant privkus.3.Pri presence of water in the composition of a large percentage of iron content, it becomes rusty.To solve this problem can only be the installation of the filter, or using activated uglya.4.Popadanie clay and sand in the water level due to the lifting of the well.This occurs when floating soils water is pumped almost completely, and the tightness of concrete rings broken.

well contamination reason is quite a lot, there are two ways to solve the problem is a mechanical and manual cleaning using a drain pump.

Shoe with drain pump

How is the manual cleaning of the well?

can attract professionals to this and you can do on its own.cleaning technology is quite simple.Typically, all the dirt accumulates on the walls of the first aquifer and the well bottom.By the walls of the stick is not sinking debris that can be cleaned with a stiff brush.Wet cleaning is suitable best.To do this, you must pump out of the water, it was convenient to handle the well wall.At low water level in the well can be installed ladder.Thoroughly cleaning the walls of the well, you can even touch it to feel clean.All the dirt is washed off with water and pumped.Gradually, you go down below, still cleaning the walls up until you reach the bottom.At the bottom of the garbage accumulates drowned.It must bring together the top layer of natural filter - the rubble.Several times pumping the water from the well, you can see how it gets much cleaner.Then you can use a natural antibacterial material.To do this, place the bottom of the well shungit or zeolite, they are perfectly disinfected water.Pay attention as well check the tightness of joints, his integrity.If necessary, carry out repair work.

Example of manual cleaning of the well

Technique drain pump cleaning

well known that modern drainage pumps are usually used for pumping water for various pollution of wells, ponds, reservoirs.They are ideal for home purification system, because they have enough power and small size.There are two types - the surface and drowned.Since all pumped water flows through the drain pump, mechanical impurities can damage it.Therefore, before drainage is necessary to carry out a preliminary purification of water from various debris.Advantageous to have a pump with a float which indicates the level of the pumped water at the right moment and disables the device.This ensures that you use the pump idle and future breakdowns.However, there are some drainage pumps which handle even with very contaminated water and the presence of impurities and solids up to 3 cm. Most often it is the immersion option from Karcher.

Sump Pump Karcher

Video - cleaning the well with their hands