Composite tiles - a roof with minimum load

Composite tiles - nothing more, nothing missing

Both surfaces of thin steel sheet covered with layers of aluminum alloy with silicon and zinc, in addition, the outer side is sprayed acrylic particles of natural stone.That's what can be briefly described roofing tiles, which is formed as if a small area is covered with natural tile.

This appearance can be one way or another, including wood, but the structure is always the same.It is thanks to the listed sections of shingles did not corrode, which is beneficial to its lifetime, corresponding to an average of 50 years.

to composite roof was the most effective, it needs proper installation. special bends should be used on the roofing sheet so that the connection was very strong and did not arise unplanned gaps.

When assembling care should be taken not to damage the top thin layer of clear acrylic glaze, thanks to which the material is self-cleaned by applied to the dust and other foreign particles.However, in the event of defects surface can always use special repair kit, which is necessarily attached to each sold Party composite roofing.

Mounting composite shingles - just a few of the rules

Any roofing material, including the one in question is sold in packaged form, being closed from the environment with a special film, but at the construction site is desirable to cover the composite sheets fromdust waterproof material. Store material in a dry room with a high-quality ventilation to remove the package from the sheets is allowed only to close them laying .

To blow the roof was done right, the pitch between the batten bars should be carefully verified, so that the top of the paper with a special projection lying on a bar, and the bottom was connected with the next lap next tile.

addition knowledge necessary to operate the rules you should also learn to use pre-defined tools.Among other things you'll need wood saw and saw blade, metal and preferably a circular saw.It is also necessary to have a drill with the function screwdriver, hammer, scissors, metal and assembly handgun.

Certainly there is a need in the hand grip and bending klepochnike.And it will be just great if you manage to get a bending machine, even if small, the guillotine and the pressure gun for nailing.Be sure to have on hand a template for the crates, otherwise you can get in the end completely ineffective roof.Nails is better to buy special, with a notch.

Installation composite shingles in a few words

Our tiles are not simply a pack of sheets, it is composed of various elements, each of which has its place and, of course, time to use.To comply with the sequence of actions and proposes the following instructions for assembling composite shingles.They make up the bulk of the sheets, no doubt about it, but there are units for the formation of eaves, the ridge, valley.All of them are important and need to be stacked properly.

Laying composite shingles usually starts from the top down, and this is the explanation.The fact that a special bending the top of the nail plate includes an end zakolachivanie timber battens, with capture and curved bottom sheet of the top row.Therefore, if we begin to lay the bottom, it is necessary to combine just 2 sheets.And if on top of the lower number of sheets will need to simply slip neatly under the top.

When traveling on the composite coating should step on the junction plates, and it is desirable that the heel fell on timber battens.

When both of the roof will be fully carpeted with sheets, you can proceed to the most important part - the valley, bridging the gap at the junction of the ridge sheets.It is better not to delay because it may rain, and then the moisture will penetrate under the roof deck.In contrast to the rough surface of the tile, valley always perfectly smooth, and it is no coincidence, it is necessary that the water flowed freely from it, without stopping.

finished with a ridge, turn to the cornice assemblies, observing one rule strictly - nothing should prevent access of air into the ventilation gap.When installing the waterproofing film output on top Cornice strip, which, in turn, should be slightly lowered in the gutter.