Servo drives with their own hands

operating principle of the device

1. Upon receipt of the drive signal is heated details of construction, leading to expansion of the substance inside it and on the exposed first pressure rod, and then on the right.

1. device is equipped with LEDs signaling the operating position servo.
2. If the type of mechanism - closed, it is possible to connect it to other devices or monitoring of its operation.When you open this type of option is lost as a contact, allowing to make a connection, closed it.

Features joining servo

To ensure reliable and uninterrupted operation of the system with a low-temperature mode, you must have a mechanism that controls the performance of both the heat carrier, and the environment.These devices drive the actuators, which contribute to switching of the changeover cock in the desired operating mode.

Setting the thermostat facilitates full automation of heating floor heating network.Next on the thermostatic valve actuator mounted return line, the installation of which can be carried out and personally.

recommended to place the servos in a normally closed position - in the absence of an energy unit it is in the closed position, and with the appearance of his device is in working condition.

Specifications subject

• device is a two-position sensor
• stem moves in the back-and-down direction
• servo power reaches up to 2 W
• Operating temperature ranges from zero to +50 degrees
• maximum flow temperature is 110 degrees

If for heating use heating networks both modes - both low and high temperatures, the thermostat acquisition and installation of the servos will make their operation much easier and more efficient, as well as provide full automaticity system.

Manual heating operation regulation is not very expedient and less modern and more convenient than the use of servo drives, which at times make it easier maintenance and control of the system, as well as make it more reliable, since virtually no human hand is applied to the operation of the network.