As wallpaper glue butt , step by step guide

Tools Required

Tools should always be at hand to save you from tricky situations that may eventually spoil the result.In order to cause the web smoothly, it is important to have a ruler, plumb, level, meter, scissors and a small knife.

adhesive is applied with a sponge or brush, plus the need to mix pail.Wallpapering on the wall by the "butt" is often carried out with a brush spring holder, which in some way increases productivity.It should also be kept in mind that one can not avoid the appearance of wrinkles or cracks, so the surface is carefully smoothed (you can do it with a dry cloth).

Surface preparation and selection

glue Before starting the procedure, you need to remove the old layer of the coating.For this it is important to moisten the surface of warm water and left for 10 minutes.Next, begin to clean off the last layer of the wallpaper, using a narrow spatula or brush.Movement is carried out in an upward direction.When the base is completely cleared, it is checked for cracks.If there are cracks, they obscure the special means.

also check the surface for the presence of mold or mildew.If you want to eliminate their anti-fungal compounds.Be sure to give the composition after the procedure dry as spots left when processing can spoil the look of the new coating.If the room there is an increased level of humidity, additional base is primed.

best glue for wallpaper - one that is designed specifically for them.Each roll often write what is needed and how adhesive wallpaper pokleit.For example, the composition has a wallpaper base paper of modified starch and antifungal components.For vinyl and non-woven blend contains methyl cellulose, anti-fungal additives and modified starch.Also often use universal glue, when it is necessary to combine different types of wallpaper.A method for preparing each composition is indicated on the packaging.

How to hang wallpaper butt?

So, you have chosen all the necessary materials, clean the surface, and the question arises - how pokleit wallpaper?But first you need to determine whether the pattern alignment is necessary (if any pattern), and then cut them.If the wallpaper plain and combine drawing is not necessary, they cut a length equal to the height of the room, to which is added 5-10 centimeters.If the drawing has, in each of the following band, he shifted to the half of the pattern.

further prepared solution of glue and spread on the opposite side of the web.Glue for wallpaper joints desirable to apply carefully.If the edges (the joints) are dry, then subsequently wallpaper may differ.Double sheets folded inner side.Allow to stand for 10 minutes for better impregnation.In this procedure, paste temperature should not be higher than 40 ° C.After primary treatment the cloth of his beginning to re-glue process.

At the beginning of the work the room temperature should not exceed + 20 ° C. Also, there should be no drafts: air vents must be closed.Cloth applied downwards on the wall.Excess accurately cut the web material at the corners and baseboards.Used in the process of cutting ruler and a sharp knife.Do this procedure is strictly up to the moment when the dry wallpaper.