Typical layout of the heating system

Standard routing water pipes

Replace standard wiring diagram of the heating system is not so simple from the point of view of the bureaucracy.it is necessary to obtain a permit will not run on a single instance and to coordinate the intervention of the central heating system.Moreover, to make the new wiring in your home you will be allowed only if it will receive regulatory approval for the replacement of the central heating system to a stand-alone gas or electric boiler.If such approval is not obtained, it is possible to optimize the heating devices, replacing them with greater heat dissipation, such as aluminum or copper radiators.

privately owned process of installation of the heating system is simplified.There is no need to consult and obtain authorization from the competent authorities.Therefore, the wiring in a private home usually make the collector.This scheme allows you to maintain the same temperature throughout the house.

Typical layout of the water supply system is based on the series connection of all components to the horizontal central pipe.In turn, the central horizontal pipe embedded in the vertical riser of water, which is located near the sewer for the outlet of the riser.According to this scheme has a certain standard wiring structure.

The vertical riser in the bathroom, cold water supply, is welded fitting extending horizontally.On it is mounted faucet, and if desired, and the counter on the consumption of water.Behind the counter is set tee, from which pipes depart in the cistern.

Following the first tee pipe passes to the bathroom, where another set tee separating the wiring to the sink and bath (shower).The same happens tee connecting the washing machine to the water supply.However, when installing total washbasin second tee, you can not mount.

dishes Water supply connection is carried out on a separate riser, if it is an apartment with improved design, and if small-sized housing, the pipe to cut into the riser, which is located in the bathroom.In this case, the first tee is replaced by the crosspiece.The layout of pipes, feeding hot water, is carried out by a similar method.Driving: a vertical riser - the union - tee - and access to a kitchen faucet in the bathroom.

optimum circuit layout water pipes - collector

Change the wiring diagram is a personal matter for each owner, especially if it is a connection to the water supply system to the private home.If only it was not illegal connection and it was convenient and comfortable for you personally.In most modern houses the owners are willing to make a prospective collector circuit connecting mixers and cranes.This system allows more even supply water pressure and no pressure drop, if one branch energized several plumbing fixtures.

collector scheme is as follows:

Behind the counter is set comb (collector).Then, each of the manifold valves are connected outputs (taps) with a dedicated line.Similar action is done with the riser hot water, powering showers, tubs, dryers, mixers exclusively through the collector.The only drawback of this system - it is a large number of horizontal flue pipe.However, if this option is not satisfied, you can use a mixed scheme, which combines elements of the collector and serial circuits.