Apply the paint for doors with their hands

Getting painting doors paint

desirable when processing doors do not use transparent toners compositions, as applied shading brush, leaving no streaks or stains, it is practically impossible.In exceptional cases, you can take the opaque or dark Colera.

best to use for painting the doors white lacquer or plain colorless , it does not create any problems at work.The tree itself has the ability to eventually acquire the saturated hue, typical of seasoned wood.Use expensive paint is not recommended for a simple reason - it requires skill handling.

For work you need the following tools: paint brush, paint scraper, sandpaper (always with a fine abrasive), colorless varnish, glossy and matt, solvent, putty and glue PVA.Paints and solvents are toxic!Carefully read the instructions attached to it.

Surface Preparation - depends on a lot of doors

Paint varnish require you some care, and should not be neglected preparatory works complex.Before the start should assess whether the product is ready for processing.It must lead to the proper mind before varnishing, it is a very important part of the process.

necessary abraded heavily smooth surface with sandpaper (fine abrasive used) should be removed all cracks, dents, chips and neproshlifovannye place.All of these defects will be very clearly visible, if not eliminated.In appearance, the surface should be smooth and matte.For small defects, about 1 mm 2, it makes no sense to pay attention - there is no perfect product.

If there are large cracks, they are wedged, and the inside is filled PVA glue.If the cracks are small, they can just paint over the glue, paint using a putty knife.After the glue has thickened, remove the excess.After working with the adhesive surface of the product treat sandpaper, then use putty.

When it dries, the surface is re-grind abrasive as putty and glue are not completely removed from the defect area.With large dents or chipped are also coming, they obscure the putty and sanded abrasive.After a simple, but requires patience to work, you can begin to paint events.

How to make the right varnished doors?

So, the next step - a priming operation.Take 0.5 liters of gloss varnish and diluted with 0.2 liters of solvent.Products must be completely rid of dust, you can use a vacuum cleaner or compressed air.

With a paint brush, apply a thin even layer of the composition of the surface.The coating lacquer doors is best done by placing the door in a horizontal state.Primer dries rather quickly, it will take about twenty minutes.After drying, the primed surface must be sanded with sandpaper, and then re-cleaned from dust.

subsequent stage of work - is the application of an even thicker layer of undiluted high-gloss varnish on the surface of the door.It is important to avoid contamination of mechanical impurities and dust in the paint or brush, and stains on the surface.Since the varnish is not diluted, it will be dry for longer, it takes about forty minutes, if the room temperature about twenty degrees.After drying polish the surface again grind sandpaper and cleaned from dust.

last step in the door - is to create a matte layer.Before the varnish applied to the surface of the door, it must be diluted with a solvent in a ratio of 1 liter of 50 g of varnish solvent.Stir the mixture as it can settle at the bottom of matting composition.

Important!Matt varnish is applied quickly and without delay, so as not to smudge left, a thick layer of neat.The last layer - the most important.If something went wrong, and the nail went bad, treat the surface with sandpaper and apply one more layer.

Thinking how varnish to cover the door?There are no specific recommendations.Of course, the best option - to look for reliable dealers of European firms to the provision of certificates and other documents.But it is doubtful whether it is practiced today, so ask around with friends, if not accounted for by the still have to deal with it.