Gates made ​​of profiled sheet with his hands

Protecting designs in a variety of fences and railings are present around most areas of enterprises and private households.The most important component of, the emphasis of the whole structure are the gate.Now, one of the most popular materials for the manufacture of the gate is profiled.

Gates made of profiled sheet to perform their own hands simply using step by step instructions with photos and video,below.

sequence works

1. First, you must select the type of the gate, on the basis of their opening systems: hinged, swing-lift, sliding.Consider the most simple version of Swing gate of corrugated board.

2. Before starting work, you need to create drawings and bill of materials for future construction.When required to purchase, according to the available specifications, the necessary materials and tools (see. In the end of the article).

3. Initially, the gate poles are made of thick-walled pipes 60h60h3h3000 mm.You can use the pipe square, round and rectangular section (optional), which are incorporated in the goal figure made of profiled sheet.

4. From rectangular tubes smaller 40h25h2h6000 mm or over, according to the scheme drawn up are made by welding the frame (frame) for fixing the trapezoidal sheet.The number of frames is determined according to the drawing of future construction.Frames are attached to the posts using hinges gate, the number and size of which are selected, based on the weight of the resulting structure.On sash set space for locking devices and locks, opening limiters.

5. The whole construction, in order to avoid corrosion, covered by two layers of primer for metal and enamel in the color sheeting.Parts of the poles that are in the earth, is further treated special waterproofing paint.

6. To set the gate in the ground drilled holes (holes) in the ground with a diameter of 250 mm and a depth below the freezing point, ie,usually a depth of 1-1.5 m. The necessary holes can be dug by hand or anchor truck, which of course will be easier, but the main thing to observe depth.Liberated in the wells stand ready to design gates, holes filled with concrete grade M200 or M250.For the stability of the structure between the posts arrange below grade concrete monolithic girder cross-section 250x250 mm, connects the entire structure.

7. Now, after the final hardening of concrete, can be performed directly from the installation of gates sheeting, as in the photo.Decking can be attached using a special roofing screws, and for more vandal - by rivets 3,2h10 mm (preferably using steel studs to avoid galvanic between two different metals that can cause corrosion).To do this, first cut corrugated board, the required size, and then installs it on the gate, with an overlap into a single wave.

8. After finishing work installed locks and locking devices, tinted damaged places.Swing gates of corrugated board in the country are ready!

Materials and tools

deciding how to make the gate of the trapezoidal sheet with their hands, the owner will need to purchase the following tools: Angle grinder - "Bulgarian", screwdriver or a rivet gun, welding inverter device, anchor truck, shovel, brush.

From the materials needed corresponding pipe sizes, angles, and other design elements, decking the desired color, locking systems, roof screws (or steel rivets), concrete, primer and paint.

Video door mounting of the trapezoidal sheet with his hands