Wiring of fluorescent lamps

most common light source used in the office, industrial and public buildings, are fluorescent lamps.In recent years, due to the energy savings, they also began to be used often and in the home.

standard lamps, in addition to its advantages such as low power consumption, easy installation, low cost, also havea number of design flaws.Part of it comes up from the advantages of: using cheap, outdated, schemes and materials, the manufacturer reduces the cost of the lamp, while pre-consumer quality deteriorates.

Wiring fluorescent lamps

Connect one or two fluorescent lamp factory production, can be explored, disassembling conventional lamp.Usual standard, widely used method of connecting fluorescent lamps includes a starter, throttle, the connecting wire, capacitor, and the lamps themselves.In this case, a so-called electromagnetic control system.

improve their own degree of illumination, remove annoying buzzing and blinking is quite real.To do this, you must replace the outdated control system to a modern e - (ECG).

To start, you need to disassemble the lamp, remove all the stuffing out of him.By purchasing a new electronic control unit, based on the parameters of your lamp, it will be possible to connect fluorescent lamps without choke and starter.For this to work, you need a screwdriver with different stings, pliers, wire stripper, screwdriver for mounting control units, electrical tape, screwdriver tester.

connect electronic ballasts for fluorescent lamps is easy to perform, with minimal knowledge of electrical circuits and electrical wiring skills.In fact, the lamp will be very block, set of cables and fluorescent lights.

Before starting work, you should choose a sufficient space for installing the electronic control unit, guided by the convenience of connecting to the terminals located in its housing in the lamp housing.Fasten the unit to the chassis with screws ordinary screwdriver.We connect the control equipment to the lamp and terminal connections.

Wiring 2 fluorescent lamps is similar, but they are connected in series, and based on this, an electronic unit power should be twice the wattage.The same principle, when connecting three or more lights, in the same housing.

, you need to make the entire structure after assembly is properly connected all the wires, then it is possible to install the lamp into place.After checking the tester there is no voltage in the network, connect the wiring to the lamp connecting wires through special terminals.

last chord, is the inclusion of the voltage to verify the correct operation of the lamp.If the circuit, for example, to connect two fluorescent lamps was performed properly, then the process of work is dramatically different from the original.First, the lamp will light up instantly, without the so-called warm-up, second low hum disappears, the light stops flashing, much to the human eye, and the total luminosity increase.

Video connection fluorescent lamps

For more information about the device fluorescent lamps: