Connect the water heater to the water with his own hands

When settling in an apartment or house, indirect hot-water supply, it is necessary to perform the correct connection of the heater itself, as the water supply, and to the mains.

Currently, various types of water heaters quite frequently set in the apartment and in his own house in the country.

This device makes it possible to completely depend on a centralized hot water supply and have in the house is always hot water.

It should be noted that the installation of the boiler allows significant savings for utilities.

Connection to the water supply system is mainly dependent on the type of water heater.

Also of great importance is the condition of the electrical network, as the water heater, as a rule, has high power performance and consumes a considerable amount of electricity.

Make the connection with their hands different types of water heaters to the water supply system in an apartment or house in the country, everyone can.

It's enough to have on hand only all the necessary consumables and tools.

main types of autonomous water heaters

Todaytime in specialty stores, you can find a huge selection of autonomous water heaters, which are equally suitable for installation in an apartment or in a private house in the country.

In order to determine the choice of the boiler, it is necessary to thoroughly understand the device of each of them and understand the principle of action.

The main and the main parameter for the water heater, which characterizes their device is the type of product.One of the types of boilers are storage-type device.

It represents a certain volume of the tank, inside of which is a heating element.

principle of his work lies in the fact that the tank is filled with water, after which it takes place due to the heating of the heating element.

To go from the tap water by using hot water heater of this type require a certain time.

In turn, the flow-type water heater heats the water directly in the pipe.

In this case, the tap starts to go hot water immediately after the device will be in operation.Video

:

should be noted that heaters each other may vary and the heat source used.

So, most frequently in apartments and private homes use electric devices, in which the main element is the heater.

addition can sometimes be found and units that operate by flame heating energy.

Despite the fact that this type of equipment is more economical, yet the easiest to install and use is considered to be electrical.

It should be noted also that perform their own hands connection equipment operating on gas, it is practically impossible, as this work requires specific knowledge and appropriate skills.

In turn, electric water heaters are connected to a water supply, and to the power supply quickly enough.In addition, a mono connection without problems to perform their own hands.

heater Choice

first step before perform independent connection of the device to the water supply and electricity networks, it is necessary to buy the right.

Currently in specialized stores is a wide range of electrical equipment, which allow to heat the water quickly.

Video:

On the shelves of the products of different manufacturers and types, which somewhat complicates the device itself a choice.Meanwhile

choosing electric water heaters, it is necessary first of all to look not at the cost, and performance.

addition and no harm will be pre-read reviews on a particular device.

course, preference should be given to well-known companies, which have already proved the high quality of its products.

is also recommended to consult with experts, well versed in water heaters electrical type.

high reliability differ heaters known brand Thermex.Manufacturer Termex have long been working on the water heater market around the world.

devices Termex have good workability and durability, and in addition, their work with the minimum amount of electricity consumed.

Thermex Company offers water heaters as the cumulative and flow types.They are mid-priced and accessible to the majority of buyers in this country.

The advantages of the brand Thermex units can be attributed, and attractive appearance.They are easy to fit into the design of the bathroom.

addition Thermex products are available in a wide range, which allows buyers to purchase a device that will suit and its characteristics, and cost.

Thermex Water heaters are easy to install as a water supply and to the electrical outlet, and unpretentious in use.

for water heating devices Termex optimally suited for use in the apartment, and private house.

Preparing the connection

Regardless of the type of water heater selected, it is first necessary to determine the place in the house where it will be installed directly.

recommended that all its elements and compounds were the most accessible place.This will allow maintenance and repair convenient way if necessary.

Video:

If the selected storage type water heater unit, the wall on which it is installed must be strong enough to safely withstand the weight of the unit with a reserve.

In the vicinity of the water heater should undergo water pipe, as otherwise there is a need to carry out the installation of additional sites plumbing.

Besides water system apartments should be in good and working condition.

should also check and electrical network that will connect the water heater.The best thing for this device will equip its socket with a separate wire and the machine gun.

is followed to prepare all the necessary material for work and tools.

to install the boiler with his hands necessarily require roulette and ordinary building level, punch or drill with a powerful shock function.

necessary to have on hand a set of wrenches, by means of which will be to connect the water heater to the water supply.In

should buy triple fittings and shut-off valves as consumables.For sealing of all connections should be to get a tow or a special sealing tape.

should also have on hand the connecting hoses.Needless connecting water heater must be performed in sequence in accordance with conventional rules.

Connecting to the water storage device

Wiring water heater is simple and with minimal construction skills can be quickly implemented with their own hands.

Regardless, material from which made the pipe system of the aqueduct, to begin to be completely shut off the water supply to the apartment.

Video:

Next, you need to perform the installation of tees, which will connect the system and the device itself.

Then directly behind the tee you need to install shut-off valve, which will make it possible to quickly cut off the flow of water into the device itself, if necessary.

In the final phase, the installation of flexible hoses, providing water heater connection to water supply.

When connecting the storage device type, be sure to observe the connection sequence of schema elements.

In any case, the first step is set tee and shut-off valve, and then all the other elements of the pipeline.

must be carefully sealed all connections, otherwise the system will necessarily flow in the most inopportune moment.

For more information about how to perform the connection of water heater in the apartment shown in the video, which is available above.

Installation flow unit

Connect to the water flow type device even easier than the water heater.

First we need, as in the first case, to block the flow of water in the apartment.This is followed by a technological pipe break in the place where it will be specifically connected device itself.

After that, the pipe is installed corresponding valves, which will, if necessary, turn off the water heater from the system.

Video:

The device is connected to the water supply by flexible hoses.Only after all the connections and elements of the unit, can be fed with water and electricity will be checked.

make the connection flow device should be carefully sealed all the places water pipe connections.

addition should be mandatory to arrange for him and a separate outlet with automatic supply.

Immediately prior to the operation of the water heater, it is necessary to check in and remove revealed defects if necessary.

For more information about how to connect with their own hands instantaneous water heater, described in the video, which is available above.