What plaster to choose - answer to the eternal question

Gypsum mixture

Gypsum dry putty - this is one of the most common types of material.The basis for these are gypsum and chalk.They have received widespread due to the low cost, durability, resistance to moisture.Also, they are suitable for further finishing of any materials: wallpaper, paint, and so on.In addition, they are easy to work.It is only necessary to fill in the water container, fill the right amount and mix all thoroughly until smooth without lumps.

Tip!About mixing proportions have to read the instructions on the packaging.

disadvantage gypsum fillers is their suitability for use for only 30-50 minutes.Then they start to solidify rapidly.It is also necessary to clearly calculate the right amount of mixture that did not have too much to throw away.However, this quality is appreciated by experienced craftsmen who are two filler layer should be done in a small area.Working with such a mixture, the main thing is not to miss the point of solidification, or a bucket and then it will be very difficult to clean up.It should be remembered that the use of a mixture of plaster can only be in the room, even with high humidity.

adhesive and acrylic blend

Putty adhesive based on distinguished by their "vitality", in contrast to the plaster.They are used for the processing of large volumes in which is applied only one layer.Work easily with them, because there is no need to mix a new batch every hour.It is also possible and the containers out of this mixture to wash a few hours after completion of the work.Making cleanup sandpaper adhesive layer solution is very simple, as a fraction of his small, no more than 0.3 millimeters.However, the price is higher than in the plaster mixture.Also, they are just finishing and not applied thickly.Use can be inside the room, but not in wet rooms.Also not recommended to apply for painting.

Note!When deciding how to choose the putty, pay attention not only on the conditions of use, but also on product quality certificates.

Acrylic putty - finishing mixture is sold as a finished product.They have been applied in a thickness of one millimeter on the other mixture previously puttied surface.They have good ductility and low consumption.They can also be diluted with water.they are used to make the surface smooth for painting or decoration.They are used for interior applications in dry areas.

What plaster to choose for all types of

In choosing fillings, we can not dwell on the cement mixture.Such fillers are intended mainly for use in outdoor applications.They are frost and water-resistant.They are divided into two groups:

• With sand;
• without sand.

first group can be used for both exterior and for interior works, for example, in damp rooms.Work hard enough with them, and the surface is not perfectly smooth turn.They have a white color as the structure includes white cement.The second group used for facade work.They can also be used in wet areas.It has gray color due to the color of cement.Sometimes, a second group is used as the starting mixture for rough alignment.

Knowing what mix which is used, you will be able to decide how to choose the putty.It is necessary to compare the tasks that you need to decide and what mix of best fit.

Tip!Be sure to read the instructions and recommendations on the use of which gives the manufacturer.