Box in the castle interior doors with their hands

Installing a lock mechanism in the interior doors can increase the comfort of living.For the installation you need a small amount of tools: drill, screwdriver.Run any homeowner will be able to work.Occupies Box Castle in interior doors with their hands about 15-30 minutes.

What tools are needed for installation of the castle?

Accuracy installation of interior doors in the castle depends on the correct preparation, used tools and components.The use of amateur or professional equipment will improve the performance reliability and simplifies the installation procedure.For the owner will be required:

• set of handles and locking mechanism;
• chisel;
• screws (are included) screwdriver;
• drill down on a tree 23 mm;
• drill and castellated milling cutter for wood (5 cm in diameter).

In the absence of tools is recommended to take them with friends or neighbors.Carefully carry out the work will not work without the use of auxiliary equipment.Learn how to embed the castle interior doors will study detailed photo instructions and advices of the master.

Step by step instructions for installing the lock in the interior doors

After purchasing the kit, training tools, you can immediately get to work.Additionally, it is recommended to study the requirements and recommendations of the lock manufacturer.Immediate tie-lock is performed according to the following instructions:

1. From the bottom of the web is measured 95 cm from the edge is measured 6cm intersection point is marked in pencil on the canvas..

2. Mark a web is transferred to the end portion of the center (using polygon).

3. The marked on the end point using the drill-pen and drill a hole drilled under the locking mechanism.

4. On the canvas using the crown cutter in installed earlier mark is harvested hole for the handle.

5. In the prepared at the end of the door locking mechanism is inserted into the hole, the perimeter is surrounded with a pencil removed from the hole.

6. Using a chisel in the end part of the harvested area under the castle (on the marked perimeter of the outer part of the mechanism).The thickness of the felled area must be equal to the thickness of the latch lock (about 0.5 cm).

7. The lock is installed and secured in the opening harvested using self-tapping screws.

8. The first set pen with screws.First, the screws can be turned out, and then the handle mounted on the door.

9. Since the second part of the element itself is removed the handle and the escutcheon (using the key supplied).This procedure is well demonstrated in the accompanying video instructions.

10. The second part of the handle is inserted into the door, fixed with screws.Set escutcheon, handle itself.Installation work is complete.

After setting the executor will only test the items and remove the resulting waste.In the future, it will require periodic adjustment knobs (every 3-4 years) due to their loosening from the operation.Lubrication of the castle is held in case of severe seizing (dust, debris).Analysis of mechanism and its processing is carried out according to manufacturer's instructions.

Tips

experts During the self-lock mounting in interior doors should be aware of neat drilling holes and cutting section under the tab.Drilling cutter to be performed on both sides of the web.This will help to prepare the desired diameter and easy to install components.Another important factor is the gradual tightening the screws fastening the handle.A strong tightening is more likely too snug fit elements and the complexity of opening the door.Compliance with these requirements will help to embed quality lock without professional help.

Video tie-in lock interior doors with their hands