Wicket door with his own hands

After the decision to fence section using the fence of corrugated board, there is a need for the gate device.It can be done without any problems if you follow the instructions suggested in this article.

for manufacturing the gate with their hands need the following tools: welding machine, angle grinding machinewith cut-off and grinding wheels - "Bulgarian", drill-screwdriver, gun mounting rivets, brushes for painting, screwdriver and level.

Drawings

Step by step instructions for the manufacture of corrugated gate

This manual provides a method of welding the frame gate directly on the support pillars.

1. Initially should mark a place in the future gate, leaving the doorway width needed in the fence between two pillars, subsequently need to weld the pipe - base frame future gate.Through this scheme, the future gate ideal size.In this case, the problems arise when the structure is made in another place, to be excluded.

2. The question is how to make the gate is easy to solve.Its frame is made of the same square tubing, as well as the frame fence.To avoid deformation of the gate frame, the pipes are welded to the posts of the fence.

3. After that, the vertical rack frame is welded the upper part of the gate hinges.

To ensure rigidity frame structure in the middle need to weld the crossmember from the same square tube.Horizontal cross-jumper should be checked with the help of the level.

4. In the next step, swing gate frame made of profiled sheet should be cut at fixing pipes to the posts.It is necessary to cut all the extra pieces of pipe, carefully provarivaya all the joints and welding joints clean using a grinding wheel.

5. Use the "grinder" is necessary to clean up the installation location of the lower parts of the hinge pins on the pillars of the fence.First, you must weld the lower part of the upper hinge, then you can hang the frame gate and post weld the bottom portion of the second loop.

6. Making the gate of metal sheets requires validation of its opening: if everything is correct - it is free to open.

7. It is necessary to remove the gate and weld hinges on the pillars of the fence on all sides with a sweep of welds.When welding hinges need to ensure the protection of corrugated sheets of sparks and slag from the welding arc.

8. Use the "grinder" cut the required space for the installation of a mortise lock, pre-allocate all the dimensions at the front gate according to the drawings.

9. The photo shows how, by setting the frame gate hinge can mark the location for the installation of mating lock strap on the pole fence.Reinforcement of strikers on the fence stand, using a drill-screwdriver.Next, check the correct operation of the lock, then you can begin to stain the entire structure to protect it from rust.

10. Using a drill and rivet gun, you should perform a pre-fitted mounting on trapezoidal sheet size at the gate frame.Alternatively, you can fix the decking, using roofing screws.Having assembled the metal profile, you need to install pads with handles on the lock.

11. To limit the opening of the gate, into the aperture, it is desirable to set the limiter from a piece of metal cut from the pipe.

Thanks to assemble the frame directly on the intake racks, work, in the presence of an assistant, will take no more than two hours of time.The very same gate will delight your newly made owners of reliability and easy maintenance.

Video installation gates of metal sheets with his hands