Technology as wallpaper glue on a paper basis

Wallpapers, perhaps the most comfortable material for self-walls, and the most popular non-woven wallpaper received basis.Fleece has many advantages over traditional paper-based - it is more flexible, allowing pasting wallpaper on uneven walls without bubbles and wrinkles.In addition, the wallpaper on non-woven basis is not necessary to smear glue, which greatly simplifies the process of gluing.To properly pokleit wallpaper on non-woven basis is enough to know the basic techniques of this work, and skill will be after the first gluing fabrics.

Buying wallpaper and necessary materials

Before you glue the wallpaper, you need to measure the room and draw its plan, taking into account the length, width and height of the room, as well as windows and doors.The calculation must be carried out after utochne6niya roll length - it can be either 10 or 15 and 20 meters.The length of the roll is divided by the height of the wall, the resulting integer number would mean the number of bands in the whole roll.The perimeter of the room with windows and doors net divided by the width of the roll to yield the total number of bands.His whole divided by the number of bands in a roll, and gave the desired number of rolls.If the roll is divided into bands with virtually no residue, it is better to buy more than one roll for pasting the space above the door and windows.For wallpaper with a large pattern that requires the selection must take into account allowances for the selection of the picture.

addition wallpaper you'll need:

• Materials for leveling walls;
• wallpaper paste selected taking into account the recommendations of the manufacturer of wallpaper.For the wetness of the walls - concrete or plaster - also need primer, preferably from the same manufacturer;
• soft roller and brush for corners and other critical areas;
• Dishes glue, such as a plastic bucket.The width of the capacity should be sufficient to wet the adhesive bead;
• solid roller rolling wallpaper;
• stationery scissors or a knife for cutting the wallpaper;
• Plummet.

Preparing walls

well glued to the wallpaper and then not moved, the wall should be carefully prepared.To carry out this work is necessary prior to finishing.

1. necessary to remove old wallpaper, especially if they are bright or dark picture.To do this, they moisten with water or a very weak solution of glue, can withstand up to disintegration and removed, hooking wide spatula.If the wallpaper is bad and depart exfoliate, you can remove only the top decorative layer, leaving the base.
   

   remove old wallpaper

2. walls, if necessary, align with the help of putty, smooth out unevenness with sandpaper, also sealed irregularities and chipped plaster.
   

   line the walls with the help of putty

3. If the wallpaper light, and the walls are uneven color, they must also be uniform in color cover layer of putty - fleece, in contrast to the paper, it is transparent, so the base can shine through.
4. wetness walls, which include the walls of concrete, plasterboard, painted walls, must be primed with a special solution or liquid wallpaper paste, and after - to dry.

glue non-woven wallpaper

As already mentioned, when pasting the walls apply the adhesive on the wallpaper is not necessarily, with the exception of carrying out work in the hot season, when the adhesive on the concrete or gypsum surface and dries instantly absorbed.Before starting work, you must close all windows and doors to prevent cold drafts.

1. Non-woven wallpaper glue butt, so it does not matter where to start to do it.As a rule, wide wallpaper paste is more convenient to start from the most significant angle - corners are often crooked, and if they account for mid-web obtained creases, wallpapers frown, and they have to be cut.Cut the wallpaper on the web can be in advance, and can be as gluing, rolling roll directly against the wall, you have to paste over.The second method is more economical consumption of wallpaper, but it is more suitable for continuous-tone wallpaper for painting.
   

   Wallpapering butt

2. glue on the wall is applied by roller, being careful not to do propuskov.Ugly, top of the wall and the joints further coat with a brush.Apply a cloth wallpaper to the wall and align the center to the edges.Plumb the verticality of its check, if necessary leveled, rolled and then the solid roll to complete removal of air bubbles and remove.Trim any excess wallpaper on the spatula with a sharp knife or scissors.
   

   crop the wallpaper with a sharp knife on the spatula

3. Next fabric glue in a similar manner.If the wallpaper has a large drawing, best to make the wallpaper on drywall, combine and trim pattern wallpaper size with a small allowance.Wallpaper glue butt, carefully laminating roller blades docking space and removing the excess glue.
   

   wallpaper docking Places rolled roller, and the excess is removed with a cloth

4. If the angle falls mid-cloth wallpaper often fall unevenly.In this case, better to carefully cut them at the place of the fold and glue the parts obtained separately from nebolshimnahlestom checking verticality poloten.Posle wallpapering before the adhesive is completely dry you can not open the window and allow the emergence of drafts, or wallpaper will depart.If this happened, badly glued areas pasted.
5. wallpaper on non-woven based glues often as a basis for further painting.On the package of wallpaper manufacturer usually indicates the type of paint, as well as the number of permissible layers.To paint using the paint for interior work, it is applied with a roller.Kohler paint in the desired color with the color scheme, thus it is necessary to mix at once all the necessary volume, so you do not pick up a shade.

on a paper basis - an excellent finishing material, a wide choice of colors and textures will create a single design, and wallpaper will perfectly blend in with any floor covering or ceiling.