Marble plaster - a great tool for internal and external decoration

surface under the marble plaster

applied Marble plaster on almost any well-prepared surface (ie, it is important that the walls were plastered previously).These may include: wooden or concrete panels, particleboard, fiberboard walls, trimmed with plasterboard, plywood, covered with acrylic or latex paint, enamel.

various defects may occur when non-compliance with conditions.For example, if the ground had been prepared, a new layer of plaster may peel off.A spot to present it on the surface, will leak.This, ultimately, ruin the appearance of the coating.

Advantages marble plaster

Stucco marble has a number of advantages.Describe them can be long, only a brief description of some of them.

• Resistant to chemicals;
• has high resistance to frost;
• not susceptible to the effects of ultraviolet light;
• very flexible, reliable and flexible;
• high impact resistance;
• diversity in the choice of color and texture;
• is an environmentally friendly material;
• easy to clean.

application technology

important to make sure that the surface is cleaned, it is dry and in it there are no irregularities, defects, cracks or projections.If the surface has been previously coated with all kinds of paints, the composition of which is unknown, it should process the alkyd solutions.

This also applies to any metal surfaces.If they have traces of corrosion, it is important to apply appropriate solutions alkyd or epoxy.This is necessary to prevent bleed-through color streaks or spots on the plaster layers are applied.

Application marble plaster is carried out on a pre-primed surface.Dries primed surface of about one day at a temperature not lower than 20 ° C and relative humidity of about 60-70%.Already ready primed surface must have a maximum humidity level of 10% and the air temperature should be between +5 to + 30 ° C.

Next decorative stucco is applied to the prepared (primed) surface.This plaster should not be applied in bad weather, ie with excessive sun or rain.Especially it is not recommended to carry out the procedure under the direct influence of the sun.

necessary to choose such weather conditions (temperature and solar radiation), which will allow to control the polymerization process and the drying plaster.This allows you to avoid the appearance of a pale shade or color spots, which are created as a result of the uneven coloration, prolonged or premature drying under adverse conditions.

decorative plaster with a marble crumb is applied using special tools and protective equipment .These are: bath volume per 25 kg of material (preferably a metal stirrer), a metal trowel, stainless steel float, Electroextension, flat brush with an elongate handle, an electric drill.Also, it is imperative that: cotton gloves, measuring tape, polyethylene, stepladder, soffit, masking tape.

There are special videos on many internet resources, describing the process.Marble plaster, video lessons on drawing which is presented on the portal will help you to create an unusually warm and harmonious atmosphere.Little practice using this technology, you get a beautiful interior, worthy of admiration.

The next step is to apply a marble plaster using a metal trowel and a steel float.In this case the layer thickness should be as short as possible (no more than 1.5-2 crumbs).After 15-30 minutes of drying is carried out grout.The base is adjusted and smoothed.This helps to wet stainless steel trowel.

surface should dry for 24-48 hours at a temperature no lower than + 5 ° C.Only under these conditions, the material is uniformly distributed and solidified.If after the procedure there color spots, it is necessary to re-apply the top layer over the entire surface of the wall.