As pokleit wallpaper on the whitewashed wall - step by step instructions

When the decoration in some homes, especially old, there are some problems when pasting the walls with wallpaper.The main disadvantage is that the walls in these homes whitewashed and whitewash removal can last for quite a long time.

However, in most cases it is possible to do without additional manipulation - with the right preparation whitewashed surface wallpaper will fall flat and will serve for a long time to the delight of residents.

In fact, the process of wallpapering to whitewash does not represent anything complex.One need only remember a few simple rules and clearly adhere to the technology.

First we need to prepare the walls.First, remove old wallpaper (if any) and to conduct a thorough inspection of all surfaces, which are supposed to hang.The fact that the whitewash, which includes lime, has the property over time to crack and crumble.To protect themselves and their repairs of unwanted consequences, should be cleaned and damaged areas podshpaklevat them.This will ensure a snug fit most of wallpaper to the wall surface material and warn domestic shedding whitewash.

Next you need a good polish all work surfaces from lumps and other irregularities, in order to then all these "nuances" did not appear on the wallpaper.However, if the coating is sufficiently thick and textured, it is possible to carry out this operation is not so thoroughly.

After sanding walls and ceiling must be primed.Soil composition is better to choose a quality, as cheap solutions are not enough to penetrate deeply into the surface and do not provide a reliable basis for the strengthening of the wallpaper.After complete drying of the soil layer on the walls of the procedure must be repeated.And as a third layer should be used with dilution water wallpaper paste.The above actions will be strengthened and how to "connect" the old whitewash in order to avoid its detachment in the future - wallpaper falling off.

Primer walls

Of course, this option papering the walls accompanied by a certain risk.If the walls were whitewashed several times, then the look and feel is almost impossible to determine the status of all available layers.To check the "endurance" whitewash, to be processed and wallpaper paste over a small area of ​​the wall or ceiling.After some time it will be possible to understand the behavior of the coating on the surface.If the result is large enough, you can continue to work, but if not, it is better to remove all the whitewash and reprocess the wall - so the result will be better quality.

In the case of a positive "reaction" test piece of wallpaper, you must proceed directly to the process of pasting the walls and ceiling.A very important step is the choice of adhesive.Currently there is a huge range of different wallpapers - from simple paper to fabric.not so high in the first case, the requirements to the glue - it must be of high quality.But when glueing "heavy" wallpaper, non-woven and tissue-based adhesive should be chosen specialty course, because it is composed of special substances that allow better interlink bulky material with the wall surface.In the case of whitewashed this point it is extremely important.

Technology gluing wallpaper is quite simple.To start the web to be cut into pieces, taking into account the height of the wall with allowances on a plinth, and drawing.When pasting whitewashed walls need to handle both adhesive surfaces for better adhesion of the material.Wallpapers are glued back to back, in the direction of the window opening to the door, and in the corners - overlap.Each panel must be glued to iron roller or sponge to remove air bubbles and excess glue.

These are the basic details, you need to know when whitewashed walls pasting wallpaper .In general, the process does not differ from the standard procedure and only requires a certain skill.