How to connect the radiator ?Video guide of the best ways to

Choose place radiator connection

battery should not only warm the air in the room, but also to prevent the infiltration of cold air from outside.It is on this principle they are usually placed under the sill.The heater should be located at a distance of about 15 cm from the floor and window sill, so he is able to create high-quality thermal curtain.It is also worth considering that the sill must not cover the battery fully.

Connection Diagrams radiators.Which is better?

most common connection diagrams following:

• -sided circuit.If you install the batteries for this scheme, their heat output will match the rate.In this case, a straight pipe and return pipes are connected on the one hand, only the upper straight pipe portion, and the reverse - the bottom.Thus, all the sections are heated equally battery.Monotube connection suitable for batteries with a large number of sections.
• Lower wiring diagrams.Heating radiators with bottom connection is used when all the pipes of the heating system hidden in the floor.It is understood that the inlet and outlet pipe are connected to different nozzles opposite sections.This radiator with bottom heat unevenly, and this scheme is not too effective.
• Asked how to connect the radiator with a large number of sections may be said that here fit the diagonal connection.Such a process can be described as very effective, as this ensures uniform heating panels and heat.The essence of the method lies in the fact that the pipes are connected to different sides of the battery.Straight pipe connected to its upper part, and the reverse - the bottom.

How to connect the aluminum, steel and bimetal radiators

To enable connection, you will need to connect a set of radiators.It includes everything you need - nuts, bolts and fittings.

Installation of bimetallic radiator can be used as the upper and lower circuits.However, it is better to give preference to the top and right connection, if the battery is no longer than 10 sections.If longer - it is better to connect the battery diagonally.

As for aluminum and steel panels, it is best to connect them in a diagonal pattern.If they are of small size - the lateral connection can be used, however, may need to install circulating pump.

From the above it can be concluded that the best connection of heating irrespective of the type of heat sink is diagonal.It allows you to evenly heat the battery, and the room in general.

General requirements

1. inlet and outlet shut-off valves are installed.
2. If you want to know how to connect two heating radiator, keep in mind that necessarily should be mounted to the bypass valves on the battery.
3. In the reverse connection of the radiator the efficiency will decrease.
4. Be sure to install the adapter in brass from the battery to the standpipe.This will avoid a galvanic couple.

Video "how to connect the radiator" will help you understand all the intricacies of the work.