Proper connection of the doorbell of the apartment

Wireless

easiest way to connect a wireless call, becausethis will require not have to deal with the wiring.The most common button and the main unit is powered by batteries, so all that is needed - to fix all the elements on the wall.The button can be put on the double-sided tape or drill a small hole in the wall and drive the dowel-nails.Sam doorbell can also be mounted on the wall or just put on the rack in a suitable room.In some models, the wireless device button, run on batteries, and the main unit must be connected to the socket, as shown in the photo below.In this case also difficulties in connection should not be.

By the way, it is recommended to install the button on a height of 1.5 meters from the floor.This height is considered to be the most comfortable for the on / off signal.With regard to the optimal installation height from the floor outlets, we talked about this in the corresponding article.

Wired

Many more questions arise if you want to connect an electric doorbell to a network of 220 volts.In this case, the actions are similar to connecting a light switch - phase starts on the button gap and zero goes directly to the main unit.Visually see the layout lived you can on this scheme:

So, if you are settled in a new building or want to install a doorbell in the house, then we must act as follows:

• Choose the most suitable place for the buttons and the main unit.
• Disable automatic opening at the distribution board.
• Make a hole in the wall for the cable, which will connect the circuit elements.In order not to bump into the other wires at shtroblenie, be sure to learn how to find a wire in the wall.
• From Stroebe finished opening draw to the installation button and the doorbell.You can do without this step, if you have an open wiring in the cable channels.
• Fix all the elements on the walls, immediately remove the front cover to have access to the terminals for wiring.
• zero Connect directly to the main unit.
• Connect the phase button with a door bell phase.
• Connect phase of a call to the corresponding terminal in the junction box.
• If the apartment is ground and the same terminal is present in the main unit, be sure to ground the call.
• Check the correct connection and turn the machines on panel.Check whether the device works.

That's the way you can connect the doorbell of the apartment with his hands.Sometimes you need to perform the replacement device while connecting technology will be a little different.In case of replacement You'll find that out from the wall in the apartment 4 wires.First you need to decide which wire is responsible for what.To do this, we recommend to use the indicator.For information on how to use the indicator with a screwdriver we were told in the corresponding article.

1. phase from 220 (on the indicator, and it worked);
2. zero on line 220;
3. wire going to the button;
4. wire coming from it.

to connect the call with your own hands you need to first turn off the light in the apartment, and then connect the 1st and 3rd wires.Accordingly, the second and fourth wire you need to connect to the main unit, then turn on the automatic panel and check that the circuit works.

way, sometimes it is necessary to connect a few buttons to a single doorbell.In this case, it is recommended to connect them in parallel, as shown in the diagram below:

That's all that I wanted to tell you about how to connect the doorbell of the apartment and the house with his own hands.We hope that the given photos, charts, and videos are clear and useful for you!

will be helpful to read:

• What tools need to be an electrician
• How to save electricity legitimately
• How to determine the phase and zero the instrument without