What you need to know about the correct laying laminate

Laminate as a finishing material for a long time gained the leading position among other building materials - and this contributed to its excellent quality.Laminate flooring has a long service life, has a graceful appearance, a variety of color range to suit all tastes.Indoors, trimmed laminate, cleaning - a pleasure.And perhaps most importantly, that it attracts customers - ease of finishing the interior of this material.Laying laminate does not pose any difficulty for even inexperienced in construction matters of the human, but all the same when it is necessary to observe some simple rules.

consistently and correctly laying laminate

You must first prepare the necessary tools and supplies, they do not need much.You will need a hacksaw with small teeth (better jigsaw), Roulette, wooden mallet (hammer), clamp, wedges.It should also take care of the film for vapor barrier and sound-absorbing substrate.You may need more electric.

Before we proceed directly to the laying of laminate, you must first lay a substrate to create a sound insulation, and on top put a layer of vapor barrier.The film will protect the laminate flooring from moisture.

starts the bulk of the work with the laying of the first plate.On how correctly it will be laid it depends on the form of the floor.The gap between the plate and the wall to be the same over the entire length of the plate (approximately 8 mm).set "wedges" in this gap.They prevent the displacement of the plates.The second function - to prevent bending deformation of the plates in the laminate when exposed to moisture or temperature.

remaining plates in turn are connected "in the face" to each other.The same applies to the second and subsequent stacking rows.Here we should pay attention to the correct dock plates not only one series, but also the different series with each other (in other words, the joint should be good from all sides).You can do packing ready-made series, but there is certainly not to do without an assistant.

And finally - do not forget about the so-called finishing profiles.They always help to hide any flaw in the installation and give the whole assembly a greater visual effect.To better understand the stacking process, you can view the video: