8 way cable mount to the wall

Outdoor wiring

to hold an open wiring, the cable must be attached on top of a decorative wall finishing.Typically, this option is used wiring in wooden houses and garden buildings, for example, in the garage or hozblok.For fixing the wires on the walls can be used with cable channels, clips or special porcelain insulators.Consider the features of each of the options.

cable channels most commonly used today fastening of wires and cables in special plastic channels.This is due to the fact that the cable channels have an attractive appearance, low cost, and most importantly - allow you to quickly fix a group of conductors in one place.In order to perform the fixation in this way is sufficient to fix the plastic box on the wall with screws.

If you want to combine several elements in one line, you can use special connection provided by the manufacturer.After-channel cable is attached, can be embedded in all cables and close the front cover (it snap).

Clips

Fixing wire and cable clip is only used when installing wiring in pipes, as well as if the conductor is additionally protected by a corrugated pipe.In this case, attach the wires to the wall and the ceiling is very simple.

If the surface of wood, all that is needed is to fix the clip with self-tapping screws for wood.The concrete wall or ceiling must be pre Drill holes with a punch, then drive a dowel, then have to fix yourself clip.All mounting technology clearly provided in the video example:

way the clips can be attached not only indoors but also outdoors.This method is suitable if you want to spend on outdoor wiring cinder block or brick wall constructions.

Insulators

Attaching wires to the wall of the insulator is most often used when installing wiring in a wooden house and a bath.First you need to fix yourself porcelain kegs, which are fixed to the wooden paneling or log cabins with self-tapping screws, then twist the strands into a tight plait and thread the it on the insulator as shown in the photo below:

To twist the wires yourself, you can buyspecial wiring antique, which is already curled.To learn how to make a retro wiring own hands, read the corresponding article.

Gvozdeva

bracket This mounting method is suitable for television and telephone cables and lines from the Internet.There are flat and round plastic bracket that can be easily attached to the wall with small studs, bundled. Very convenient mounting option, which is used to hold the cable discreetly on a plinth in the house or apartment.

Hidden

electrical wiring when installing a hidden way (Stroebe under plaster), there are more options for mounting wires and cables to the walls.Consider from the most simple and effective, the least convenient.

Plug-clamps

Plug-collars, actually, as well as plug-ties are very comfortable to use.These fasteners have a low cost and also allow you to quickly produce wiring.Ties, of course, more practical and universal, therefore we recommend to select them for fixing the wires in Stroebe.All that is needed - to drill a hole in the concrete, brick or wood surface, insert into it a special plug-tie, and then drive a special expander peg.

Secure plug-clamp in the wall even easier.You only have to drill a hole, then put in his collar with a cable as shown in the picture below.To attach the wire to the drywall, it is recommended to use a special plug-butterfly, which is already screwed fasteners (second picture).

By the way, if the wiring is already done for you and the walls need to be attached to it is another cable, you can use regular plastic clamps.For fixing such a way on the street recommended black collars which are resistant to UV!

Quick solution

To quickly perform a fixation of wires and cables in Stroebe, you can use the quick-drying solution: plaster or gypsum.In this case, we must act slowly becauseready solution hardens very quickly, and you may not have time to fix all the selected portion of the wall.Typically, the cable must be "freeze the" Stroebe prepared in every 40 cm, as shown in the photograph.

advantage of this method of fastening the wires is that we should not spend too much on the material and also possible to do without nails, without drilling the wall.The main disadvantage - the rapid solidification of the solution, so you need to plant a gypsum plaster in small amounts.In addition, to attach more than two conductors the wall will be very difficult.

Homemade staples

cable fastened to the wall with staples sticking provide a reliable guide, and will consolidate several groups of cables in one track.To attach wires stapled must first make the data fasteners with their own hands.In this case you will need either a thin galvanized steel, cut into strips or aluminum wire PTPZH.The length of each bracket must be 6 to 7 cm. Need suitable material cut into pieces, and then drilled in the middle of each appropriate hole.Then everything is simple - the wall is drilled in the appropriate places, and then driven into the dowel and produced "fast assembly".It is also possible to hammer nails staples when fixing is carried out on the wooden walls.

The disadvantages of this method is the long time of preparation of homemade staples, the probability of damage to the conductor insulation (if using galvanized steel strips), and the possible appearance of red spots on the wallpaper, when the steel starts to oxidize.This option is we do not recommend, if you want to fix the wire in the wall plaster, becauseThere are more modern and convenient installation methods.Staples used wisely in order to attach the system of heating cable floor heating.

Mounting pad

Well, the last one of the modern versions, which will secure the wire on the tiles or furniture (eg table) - the use of the mounting pads on one side of the adhesive.It's all quite simple, so explaining the essence of attachment there is no point.See the installation site, you can in the photo:

's all ways of fastening of wires and cables to the wall.As you can see, there is a wide range of fasteners that will choose the most suitable option for different applications.

Also read:

• What are
• cable channels Ways of electrical wires
• How to determine the phase and zero the instrument without