Gas boiler from the gas cylinder accessory for the garden

If the central gas supply is not available, heat water and cook food is necessary with the help of gas columns and slabs, able to work on the tank with gas.

used for heating water gas cylinder contains gases such as propane and butane.They are byproducts of oil refining, gas and gasoline.The cylinders may be present only technical butane or a mixture of butane and propane, which is the summer and winter.Data compression

gases converts them into a smaller volume of fluid (and thus is called a liquefied gas), and when the pressure starts to pass this liquid into a vapor state.Since the rise in temperature causes a strong expansion of the liquefied gas tank is usually filled to 85% of its volume of liquid gas so there is always a layer of vaporized gas.

for cottages range of heater is used as the energy source of the bottle, often acts as the only option available in summer conditions, hot water.In situations where a cottage is not let down a gas pipeline, and there is a problem with the mains, gas water heater of this type will be a real salvation.

When using the heater connected to the gas cylinder, an average of one gas tank capacity of 50 liters is sufficient for a minimum daily supply of hot water two or three people for a month.

balloon, which will be connected to the gas column, shall be equipped with gear to stabilize pressure of 300 mm water column, and the minimum capacity of the vapor phase 1 m³ per hour.Also pay attention to the selection of hose - its length should be up to two and a half meters and inner diameter must be 12 mm.It is important to buy a hose that will sustain the work of the column in the gas tank.

it impossible to bend and twist when installing the hose.If the hose has to be installed with a bend, for this use adapters and follow the bend radius (it should not be less than 90 mm in its outer boundaries).Furthermore, the hose should not be bent within 50 mm from the tip end.

Install gas shut-off valves must be carried out before the column so that this crane was easy to get.After completion of installation work hose and other connections should be checked for the timely detection of leaking areas.Only after this column can be used to heat water.