Masonry walls made of lightweight aggregate concrete blocks

This article Stroy-shkola.ru site will tell you dear builders on how to make the lightweight aggregate concrete masonry units with their own hands.This article will consider highlights alignment blocks, masonry corners and the correct laying technology.

first necessary to prepare a solution and to take him to the place of our masonry usual solution is in a ratio of 1 cement bucket into 4 buckets of sand, but it all depends on what kind of cement for laying you use, but normally the proportion found in these limits.

Step 1

We will lay our blocks ue to the existing structure, and an example from approximately the middle of the construction of the wall, but it will not prevent the erection of the wall you will learn the technology of lightweight aggregate concrete shreds.

Laying the first block

seam attention when laying the blocks should be equal to a height of 1 cm!

When laying the first block closely align its horizontal and vertical, to continue to get a smooth masonry always see its location relative to the previous block.

Step 2

Continue laying the blocks one by one

Please note that all the vertical and horizontal joints of course should be how to miss the mark with cement to avoid gaps.

Also, as you can see in the photo above of a layer of insulation stick some connections they need to bend the hammer, so that they do not interfere with us in the future to put the blocks.

Step 4

Set up Stroebe on 2 rows

Next, you need to make sure that the brickwork near the window opening is made carefully and strictly horizontally, it is very important, and to ensure that the same level is not enough.A good builder must be at hand plummet plummet - is a homemade device that can easily be done from an ordinary string and tie the other end of a heavy object - it will check the horizontal level masonry.

Step 5

masonry Check using a plumb

Once we have verified the correct stacking blocks, then stretch the normal cord in order to serve us a level for laying the remaining blocks, note that the cordyou need to pull a good tension, because if you pull the cord is not very much he can sag in the middle of the structure.

Tightening cord

Cement put about 1 cm

Step 7

masonry walls made of lightweight aggregate concrete

blocks Thus, we have examined the technology of laying aggregate concrete blocks, hope nowyou will not have issues related to how to build a wall with their hands.

In continuation only advise you to read: about laying bricks with their hands