Budget repair the toilet with their own hands

Conducting quality bathrooms in the apartment repair involves the need plumbing work, that complicates the task.Nevertheless, the budget repair the toilet with his hands - the task is quite feasible.This will require thoughtful design space, determine the materials and plumbing fixtures.But most importantly, you can find detailed instructions on carrying out this type of repair, we want to offer you.

Trust, an independent execution of works not only reduce the cost of repairs, but also allow you to reveal their creativity and implement them on a particular object.Just keep in mind that venturing repair such an important room as a toilet, it is necessary at a time when no one is home of relatives, not to cause them inconvenience.

Preparations for repairs

So, to properly prepare the toilet for repair work with their hands, need:

• Clean the entire surface of the walls and floors of old coatings and screeds if necessary.Wallpaper and paint are removed ordinary trowel.Removing the tile is better to do a puncher.
• If you plan to change the doors, it is necessary to completely disassemble the door frame with the door leaf.If the door status censures you is not, you can simply close the film.
• Remove the ceiling and move all the furniture.
• dismantle plumbing fixtures scrapped.

If the apartment someone was staying, the toilet can be as long as leave.It can be removed before installing the new tiles on the floor.After all the plumbing will be dismantled, and the walls and the floor is completely cleaned of old unwanted longer coatings entire repaired surface should be thoroughly vacuumed and cover the liquid primer for concrete with deep penetration that will greatly enhance the adhesion of the coating.

Installation of communication networks and wiring own hands

Sometimes in the process of repair in apartments have to carry out the replacement of sewer and water piping, as they are long enough to use and are made not from the finest materials.Most often, the central risers are found in the toilet, so this event and is held in the process of repair of the small room.Traditionally, old cast iron pipe was changed to the polymer, which are represented in the required range in the construction market.

Whatever modern materials were used for the construction of utilities, located in the most prominent place, aesthetics and charm they do not give the room.For this reason, the pipe must be well hidden.For this purpose, gypsum board or plastic box collect desired size and form, that the veneer decorative material used for finishing the entire premises.A practical solution is a combination of drywall with a screen of roller shutters.This allows at any moment access to the pipes.

Another effective way to hide utilities - hide them in the walls.For this punch in the walls breaks Stroebe, which is placed either not very thick sewer or water pipe during installation.Then it is sealed plaster solution or disguised as tile.

toilet When preparing still need to decide which will be installed lighting fixtures and sockets.When you plan to install an additional point, it is necessary to prepare a place and make pulling the wires to it.For safety reasons, the electrical wiring must be done from a single piece of electrical wire in double insulation.Absolutely all of the wires in the toilet should be under a thick layer of plaster or under the wall of the drywall sheets.

trim surfaces in the toilet with their own hands

After all communications, stage finishing work begins on the walls and floor.As a finishing coat on the bathroom wall, you can use water-based paints, washable wallpaper, decorative plaster moisture-proof, and others. However, often the toilet is covered with tiles.Her advantage is that she is not afraid of humidity and it is very easy to clean.

Finish tiled

tiling primarily produces high-quality alignment of the working surfaces.They must be perfectly smooth, tile stickers to use a minimum of glue.It is important not to save, and that only a very thin adhesive layer can guarantee quality laying tile.Alignment is done by plastering on beacons with reinforcing mesh plaster.The floor is made with special waterproofing screed laying.Run it can be wet or dry, but is perfect to use self-leveling mixture.

Installing tiles on the walls should be done after applying the exact markings and guidelines.The adhesive solution was applied in a thin layer on the tile with a notched metal trowel.Then she gently leans against the support in the form of a special plastic cross and then to the wall.To achieve the maximum possible adhesion to the wall by gently turning the tiles along the line.In the course of each laid tile necessarily checked in all directions using a spirit level.

laying tile on the floor starts from the far corner.To do this pre-layout drawing if necessary.Here you need to pay attention to the figure, which is supposed to be on the floor.Everything should be beautiful.Sometimes it is necessary to displace or undercut the first tile to figure appeared in the middle.The same need may arise if you need to be at the entrance of whole tiles.After full placement throughout the tiles, it is necessary to give enough time to dry.Most often it is 2 - 3 days.

The next step is to finish the bathroom tile grout joints.In this case it is possible to use special compositions having cement matrix.These include silicone or epoxy grout.The color composition should fully comply with the most tiles.In order not to mess with tiles, it is necessary to paste over the edge of the paper masking tape.When using a rubber spatula, must be applied over the seam small amount of grout and gently push inward.You can use a piece of insulated wire corresponding section.After complete drying of the masking tape should be removed, and the tiles are well cleaned.

trim plastic panels

If you decide to decorate the toilet tiles, for some reason, you can use a simpler method.The use of plastic panels do not require any special skills work, as is the case with tiles.Paneled PVC walls look is also quite decent.Furthermore, with this method no need to align perfectly wall, all communications will be hidden under a panel.The only drawback of this method is that you have to say goodbye to a certain amount of space, as the panels are attached to the crate with a thickness of not less than 5 cm.

In this case, the preparatory work of the same, but careful alignment of the walls is not required.They are guides for the crates are set by the building level.It may be conventional wooden blocks (not desirable) 5 cm thick or galvanized steel guide profile.It is made specifically for mounting batten, so it is easy to install and convenient to help in the hole to reach all communications.

Mounting panels made from the far corner.They are fixed with galvanized screws to the crate and are inserted into each other by connecting the tongue in groove.When the walls are closed, all the angles you need to glue the corners using silicone sealant, as moisture does not get inside the walls, so as not to give rise to mold and fungus there.At the stage of mounting battens in places where you expect to hang on the wall cabinets, shelves or mirrors, you want to install additional profiles for rigidity.

final stage of repair toilet

own hands The final stage is the implementation of the repair of the ceiling, installation of plumbing and electrical devices.The easiest way to paint the ceiling latex paint, but it would be logical to use his finishing all the same plastic panels or polystyrene tiles.Attach them to the ceiling in two ways.The first method involves gluing on a normal tile adhesive.For this purpose, the ceiling was perfectly smooth and well-primed.The back side of the tiles is greased in several places with glue and with force pressed against the ceiling.Gluing can be parallel or diagonally.Note that this tile glue specifically designed for her glue is not very convenient, so long as it is not grasped.It is best to use liquid nails.

In the second case, the frame is constructed of the guide profiles, as well as on the walls.Underneath spend wires for lighting.On the frame is attached plastic panels using screws.The advantage of this option is that such a ceiling can be installed built-in spotlights, which can not be done with other finishes.Today, commercially available special lamps that light up when you turn gradually, not blind eyes sharply at the entrance to the toilet at night.Between the walls and eaves ceiling make polyurethane or ordinary plastic corners.All slots must sizing sealant.

Installation of hinged objects made in those places where you are made more rigid crate, especially shells.In place of its attachment must be thick block of wood under the crate.However, in the case of wall panels of PVC better fly sink, which is not attached to the wall and mounted on a pedestal or pedestal.If the toilet is separate from the sink, the problem is much less.After all, it only need to install the toilet.There are no shelves and cabinets in it do not because there is insufficient space.

Installing toilets is carried out on 4 dowels to the floor.To drill a hole in a tile floor, a corresponding need diamond drill diameter.Drill very carefully, periodically wetting the place of drilling water, as by friction tile can overtempered and its top decorative layer will turn black.Carelessness during drilling can lead to cracking tiles.

What tools and materials required for the repair of toilet own

to repair the toilet in the apartment, it is necessary to prepare a specific material and hand tools:

1. electric hammer and drill, screwdriver.
2. film to close the door from dust
3. paint roller.
4. spatula and trowel.
5. Clamps, corresponding to the selected material finishes.
6. Building bubble level.
7. plastic panels (if used).
8. Plasterboard with water-resistant characteristics (color is green cardboard).
9. adhesives and ceiling tiles.
10. Trowellings.
11. primer deep penetration in concrete.
12. cement-sand mortar.
13. ceramic tiles on walls and floor (floor is better to use granite - it is less slippery).
14. finish coat, which you have chosen for the ceiling.

Here listed everything that you may need.The choice of a resource is determined by the choice of repair method and materials used for the event.

, spending is not a lot of money, all you need to carefully think through and count to completely overhaul and repair the toilet in his apartment.At the same time the economy should not be at the expense of quality.Proposed options for higher repair cost enough.Even finishing tiles will not be very expensive, because the toilet area is not large, and the material will need a little bit.Independent execution of works even more to help you save money.The main thing is to observe the instructions and recommendations.