Film warm floor with their hands

Underfloor heating as a kind

Underfloor heating is a very popular type of insulation.It can be used both independently and in combination with other heat-generating appliances.Underfloor heating creates a comfortable temperature near the surface, which affects particularly well in children's rooms.

warm floor with their hands In addition, the use of a warm floor as an independent heating element allows you to get rid of bulky radiators, and change the design of rooms, for example, to design a so-called "French windows" - from the ceiling to the floor.

Film warm floor is very simple in installation and use, and it can and must be mounted by hand.Film warm floor can be laid at virtually any type of floor finish.It is especially popular during installation under laminate or linoleum.

We expect the number of materials

first step in the work on laying a film of warm field is the calculation of the necessary number of the heating elements.

You can draw a diagram on graph paper and calculate what you need footage of the film.

In drawing up the plan you will also need to provide accommodation of connecting contacts and temperature sensors.

The leveled flat surface must be removed.To remove construction debris, you can use an ordinary brush.

Puts warm film floor

from a roll of film warm floor cut into segments to form a surface film warm floor.Please note that the underfloor heating strip must not touch or intersect.

Warm film floor can be cut with scissors.When this film can be cut not only at the point indicated by the manufacturer, but also to any other.

When cutting the need to fall into the gap between the heating strips.

ends of the cut strips are isolated using ordinary adhesive tape.If the cut extends along the line indicated by the manufacturer, it is necessary only to isolate the collector plates.

If you cut the heating element between the bands, you need to hold the insulation in all edges of the film across the width.

prepared strips are arranged throughout the room ceiling surface.When the film layout should follow the prearranged plan, and then mark the places where there will be hacked by Stroebe electrical wiring.

After that, take the foil and mark on the floor of the channel location for the installation of a temperature sensor.

Width Stroebe under the sensor should be about two centimeters.

sensor also for wiring channel can be cut with an electric punch.

So will look like seats under the floor wiring warm film.

The channel cut through for the wiring of the temperature sensor is located.For safety, it is necessary to place in the Corrugated.

Spend extra cleaning the surface of the room.You can use an industrial vacuum cleaner.

After cleaning the premises is necessary to expand on its surface a layer of thermal insulation.

strip is then laid over the strip heating elements, pre-prepared and isolated ..

Laying carried out according to previously created drawing.

connecting cables in the joints crimped contact.

Here thus seem prepared contacts.

laid-band heating elements are connected by connecting cables.

Contacts to bands and cables crimped with a special tool.

So look heating elements connected by the cable.

After connection of the heating elements is necessary to isolate the open contacts.

Here is the connected strip of film warm floor with isolated contacts.

After connecting the entire chain, measure the resistance of the resulting structure.

resistance laid on top of the warm film floor protective layer is laid.

in dense polyethylene can be used as a defense.It will protect your floor heating by water leaks.

One layer of polyethylene should go to the other about twenty centimeters.

Mount topcoat.

laid on a warm film floor you can mount any floor finish.In this case, on a warm film floor laying laminate is produced.

stacking plan and the recorded value of the design resistance is marked on the back of the warranty card film warm floor.

Video - warm film floor with their hands