Design and construction of the guest house with their own hands bath

Guest House-bath can be a great place for private relaxation or, on the contrary, haven for noisy company.The availability of this facility at their summer cottage solves a lot of problems, including the shortage of places for guests, as well as the opportunity to warm up and to celebrate an event with friends without the hassle of bringing household.

Project guesthouse with bath

construction of a guest-bath home in the presence of hard-working hands, building skills and the required amount of money becomes quite uncomplicated affair.Overcoming the difficulties awaiting any country site owners when deciding on the establishment of such a structure with his own hands?

project selection and budgeting

The first step is to determine what kind of house-bath to be built?To date, the most popular two-story structure, which occupies the first floor bath with steam, and the second is given a room to rest.On the creation of a guest-house of the bath sample and will be discussed further.This building has a number of advantages:

• not take up much space - just 25-30 m2 area;
• saves money - excludes spending on additional meters of foundation and roof, heating;
• improves comfort - no need to go after a bath from the bath into the street, just enough to climb to the second floor.

Before the construction must be puzzled with the creation of the future home plan.Decide on the location of the guest-bath home on the site.A great number of different construction of the projects can be found on the Internet, however, the most interesting is the variant of self-development drawing.

On the ground floor, as mentioned above, to place the bath: a waiting room or hallway, washroom, and a steam room.The size of these rooms are defined by the rate of not less than 3 mfor a comfortable stay of one person.Particular attention should be paid to the location of the furnace: a place to lay the wood should be displayed in the dressing room (hallway), the heating part - in the washroom and steam room, where stones are placed further steam.If desired, it can be fitted on the first floor of the shower, a small swimming pool, toilet, billiard room and so forth.

drawing the first floor of the house with a sauna

second tier often allotted to rest, and the whole space is left as a single room, soand partition oneself off to separate.

Project Plans guest a country house with a sauna

defined the flatness, go to the drawing up of an estimate of costs.Its main article:

• foundation;
• wooden components: materials for the log, floors, ceilings, roofs, stairs, porch, interior walls, etc .;
• roof;
• insulation and vapor barrier: asphalt, roofing material, mineral wool, hemp, etc .;
• accessories: staples, nails, screws;
• windows and doors;
• oven;
• materials for communications;
• materials for internal and external cosmetic finish.

All of the above can be purchased in bulk, if you allow cash or partially, as required.The first option is preferable to the fact that the total amount may be assessed fairly good discounts and even a gift in the form of free shipping.

Site preparation, foundation and plinth

degree of labor intensity at this stage depends on the quality and composition of the soil, its wetland, the availability of groundwater.Preparation areas with black soil, loam or sandstone in the relative distance from the reservoirs reduced to grass mowing, cutting of trees interfering, grubbing of stumps and leveling the surface.On the wetlands will have to make a partial replacement of soil or create a guttering system.

When choosing a foundation best stop of the bar of asbestos cement pipes.Number of pillars it is calculated on the basis of the following requirements: at each corner, along the walls through the meter, along the walls and a half meters.The pillars are wrapped with a piece of roofing material to avoid freezing to the ground, placed in the pit, about one and a half meters deep, the bottom of which poured a layer of sand.Further, the tube is filled to 20 cm of concrete, sprinkle with crushed stone and tamped.More information about the construction of the foundation on our website.

Construction of the foundation for the house

To create a cap is necessary to dig a trench depth of 30 cm and its bottom covered with sand and ordinary masonry bricks lay on the entire thickness of the pipe foundations.With the creation of the masonry wall in the ventilation pipe and the clutch wire itself is attached to the posts.

Strip foundation for the house

finished basement waterproofing as follows: the surface of the cap lubricated with hot bitumen, which is glued sheets of roofing material, then a layer of bitumen layer of roofing material over and over.

on the location of the washroom and constructing steam header.To do this, dig a hole to a depth of one meter, the walls of which tamped, coat with clay or cement.From the pit output to the sewage pipe, the approximate diameter of which is 15 cm

floor, walls, roof:. Choice of materials, the process of assembling and finishing

on the prepared foundation set joists for the floor of timber the size of 150x150 mm, and then lay subfloor,layer vapor barrier, insulation and finishing of the floor.Rough sex in the washroom and steam should be installed with an inclination of 10 degrees to ensure the water flow.

As a material for log home is best viewed Round or manual felling timber, profiled or natural drying edged timber.Before starting the installation, you must cover all the components of an antiseptic.The lowest log or timber should be somewhat larger than the others in size.Corner connection may be different:. "Paw" or "cup"Each crown is required to shift the moss, hemp, flax and jute.Mount partitions.The inside of the carcass covered with glassine and insulation, depending on preferences, trim paneling or imitation beams of wood of various breeds.

process of erection of walls of the house

ceiling, and he also has the overlap between floors, consists of a log the size of 150x150 mm, nailed wooden flooring thickness of 3-4 cm at the top are the nails. To create needed roof beams 100x80 mm size.In the past crowns every meter of doing a dredging depth of 7.5 cm, which is mounted in the beam, the upper parts of which are interconnected beam.All construction staples and cover the crate from the boards of two centimeters thick.On the outer part of the battens secure the roofing material -. Roofing, corrugated, steel, tile, slate, etc. On the inside of the crate roof and ceiling covered with a layer of hydro and steam insulation, insulated, obbivayut clapboard or imitation logs.More information about the construction of a pent roof for a bath we have already mentioned.

Erection of roof

oven steam

Selecting the most important element of the bath depends on the size and intensity of the heat, and fuel.Most often used the so-called furnace batch heater, metal, subsequently obkladyvayut brick and stone.It can be purchased ready-made or if special skills, mounted in place on their own.For firing a furnace suitable wood and coal.About furnace for a bath on our website.

Homemade metal stove for baths

To summarize, it must be said that the average life of the guest house, a bath is 50 years.Using quality materials and approach to business "with soul" extend the period for an unlimited period of time during which the building will delight you and the envy of neighbors.

Video - guest house with sauna and pool gazebo