Proper connection of the gas stove with his hands

independent connection scheme

gas stove The photo shows how important are arranged for the device plate devices.And in words, it looks like this: from the pipe in the kitchen, extending from the ceiling in every apartment (called a "riser") is a branch, referred to as "dropping the" a place that serves the direct connection plates.Crane is located at the end of falling, which is secured by rezinotkanny hose, or in other words, the gas path.

Rubber allows the device to move in the direction you want.How is the connection of a gas stove for the scheme, now you know, but it is necessary to learn some of the nuances of the compound.

Tools for installation of a stove with his hands

1. Tools:

• Keys №1, wrenches and spanners.
• Screwdrivers and clamps.

• Gas hose.
• Ball hose.

How to dismantle the old appliance?

1. tap Check for standpipe, burners and closing them.
2. opening of locknuts on the standpipe.
3. clutch Fit on the standpipe.Clean it from old paint.If necessary, you can use the grinder.
4. Moving the old plate from the wall.
5. Screwing out eviction using the key if you want to change the valve.
6. Setting caps on tap for your old device.

omitting connection to the tap

is due to the new premises on the crane lowering the pipe so that the gas can not escape.Twisting occurs to the extent that the seal does not cease to allow the tap to spin.Sealing tape and provide loktayl fum.In the case of gas leakage, the action is repeated again.

mount flexible hose

1. Wind the seal on the nipple.
2. Screw in fitting.
3. Check thread.
4. Install adapter.
5. Mount conductor screwing the hose.
6. Check system performance.

Installing cylinder on

testify to realize the connection of a gas stove in the country should prepare a bottle and flexible hose.Also, the specifics of this setup is that you need to replace some of the burner, so that they are not smoked and soiled dishes, as well as test the ignition device, if any.For villas often pick up the stove at low gas, but it is not quite cope with the flame and goes out.

As for rubber hoses for installation, first of all, you need to check which exit to the plate and thread.For once selected thread adapter, which can be included.

Important!Do not buy tubes that were in use, because the quality assurance no one will give you to them and depends on them your safety.

tips plates connecting yourself

you are almost ready to be installed, but in the end, each installation must take into account the following parameters:

1. Only certified hoses optimal length up to 5 m
2. to design a hose.Do not use paint.It is much better to use adhesive paper and oilcloth.
3. All components of the pipeline should not be hidden from the inspection and if you suspect a leak must be available for verification.
4. Make sure that there are no "additional compounds" that might violate the technical specifications used.Since it can cause fines and disconnection of gas supply.

theoretically connect gas stove really hold their own, but if the technical work - not your strong point, and the mushrooms were not before, you may need to turn to the masters of the gas service.If, for example, incorrectly assembled plumbing pipes communication threatened breakthrough and financial expenditure, the gas - more dangerous, and the risk is not worth it.