How to connect a switch with a socket

Plug-one switch + socket

To connect the power switch + socket should connect five wires in the junction box.

1. Green, specified in the scheme represents a grounding cable, and blue - the zero point from distributing.They are connected directly to an outlet in the unit.
2. Red indicates the phase that is connected to a power outlet, and then merged into contact device voltage cable.
3. remaining two cables attached to the two terminals, which are, in turn, are reserved to the two lamps are connected and pressing the button in the bathroom.

instrument device assumes that there are three cable outlet: the phase, zero and grounding switch is also only connected to the lower terminal phase (zero goes to lighting fixture).However, the upper part of the contact phase will be only after the button.

Electrical wires in a box of distribution are divided into two twisted wires as in the diagram (yellow and beige color).On wires with a voltage of light bulbs twisted wires similar switch.Cables with zero voltage and the ground for lighting served with distributing boxes and socket connection joints.

Note!If you want to reverse the order for the operation of the keys just swap cables yellow and beige on the switch.

Mounting block with one-button switches and sockets connected in the same way, only a single cable drops, yellow or beige.For the three-key switch needs shestitizhily cable, additional entries which will be connected next to the yellow and beige on the third contact.

Connecting three or four outlets in

block to install several electrical appliances (household appliances, computer and phone) use block sockets located under the same distributor.

Mounting multiple outlets in the same block in parallel.

Before connecting the device, make the jumpers of three wires in each location of the outlet.Jumper size should be such that it provides an easy, but surely fit in the box.

unit of the three outlets set as follows:

1. Analysis on the components of the outlet.
2. Stripping cables and power jumpers.The wire from the distribution point should be slightly in advance so that in case reconnection it was enough for a new sweep.
3. first outlet, it also distribution, is connected to the mains.
4. Setting outlet in the mounting box.
5. Accession second outlet during a parallel conducting wires according to the colors.
6. Connecting third outlet: it is connected only three cables, as a normal single model.
7. harbored unit under the cover with special sections for each of them.

In the video you can see the process of connecting the unit from the wall outlet and switch.

The installation is completed, success!