How to mount a double outlet on the wall

device triple outlet

mounted in the wall tees are used to connect to the network up to three electrical appliances at the same time without using additional power strips.This outlet represents the structure of a dial three common single feeding points which have the same drive.

to triple socket on the wall looked more aesthetically pleasing, it is the final element of the common external border, which combines three devices in one composition.

How to dismantle a triple outlet on the wall

Before to the above process, it is necessary to prepare a few tools:

• screwdriver with plastic handle;
• insulating tape;
• rubber gloves and shoes with rubber soles for electricity (in case you decide to work under stress).

Note!If you do not have experience with electrical appliances under voltage, it is better not start.Safety forbids it to do even experienced electricians.If you do not have the gift of immortality, it is better to turn off the electricity in the short period of the dismantling of the wall outlet.

process of dismantling the triple sockets consists of several turn-based events:

• Preparations
• Extract fixing screw fixing
• Disconnecting stops
• Removing the device from the cable

consider in more detail each of the steps mentioned above.

Step 1. Preparations

Before you begin work on dismantling the triple socket in the living room, you need to turn off the mains voltage throughout the apartment.Then worth several times to verify the absence of voltage indicator, and only then proceed to the dismantling work.

Step 2. Extract fixing screw

Please disconnect the outlet top cover to gain access to the mounting screw, then use a screwdriver to unscrew it.After that you can completely remove the top cover of the socket, thereby gaining access to the "innards" of the electric device.

Step 3. Removing the mounting stops

Rosette kept inside the box using the special fixing stops.They need to loosen by unscrewing the adjusting screws.Now the body points can easily pull out of the nest.

Step 4. Disconnect the device from the cable

final step in the dismantling of a disconnection of the cable.The wire is attached to the device using two screws and disconnected by their unwinding.All the process of dismantling the triple outlet end.

Then you can replace the device at a new mirrored by performing all of the above operations.