Toilet tank fittings

Design cistern

valve device design tank depends on the type of installation.The main working bodies of valves are filling and emptying units.In turn, they are formed with some of the smaller parts.

The main elements of this device are:

• regulatory mechanism - usually made in the form of a lever or button.
• Float - controls the level of water in the tank, connected to the trigger toilet.
• ball valve and lever - allows water to flow into the reservoir cistern
• Siphon - provides ingress of water into the bowl

should be noted that a separate locking mechanism in the cistern there.The valve closes the flow of water, back to the place by its own weight.But the device is supplying pods into the tank, it is more complicated.It consists of a feed nozzle, a valve, which is put on it, and the float.

principle of this mechanism is that the settling tank to the float tank bottom valve opens and allows water to enter inside.Once typed the necessary amount of water, the float comes up, thus closing the valve.

How is toilet tank fittings

Before you get started, it is recommended to make sure that the brand set of valves coincides with the mark of the toilet.This is much simplify the installation of the drainage system and ensure its long and reliable operation.

preparatory phase

Immediately before installation should buy a wrench, two-inch adjustable wrench, screwdriver and pliers.Also handy ball valve and hose.After all materials and tools are assembled, it is necessary to begin the installation of the tank.It runs purely on the recommendations, which are included washroom equipment.After the previous operation is performed, it is necessary to do the installation fitting with the water pipe line fitting to drain the system.To do this, mount the tap on the water supply pipe fitting and connect the hose to the tap.

Installation water supply systems

further connects the float valve and the tank fitting.At first it is screwed nut is placed on top of it and the seal ring.Socket is passed in a special niche in the tank body and the outside is screwed a second nut.Both konrgayki closer to each other until completely fit fitting to the body and the formation of tight connection.Next to it is attached funnel connecting hose and seal.

Installation of water drainage system

penultimate stage of the work is to install the drain system.Need installation of shut-off valve on the fitting.Then he fastened to the lever via the drain rod in the toilet lid on this lever is mounted flush button.This is the basic installation diagram that when another device of the tank will look a little different.

regulation of reservoir

After toilet tank fittings toilet is installed, you are ready to configure it and regulation.In order to achieve this we need to fill the tank with water.Ball valve that was installed earlier is opened and water flows inside.While it is necessary to trace the movement of the float - it must float on the surface of the water, without touching the walls of the tank and parts of the locking mechanism and filling.Also it is used to set the height of the ascent of the float.Recommended operating conditions:.

• time filling the tank - 2-3 minutes
• water level - lower edge 5-7 cm

Repair valve toilet tank

If suddenly there was a constantflow from the reservoir, or by pressing keys drain water does not flow into the bowl, the toilet tank fittings toilet is broken and in need of repair.To do this, close the valve feeding water into the tank and empty it, then remove the junk and install a new valve.It is not recommended to change individual parts for reinforcement, as is likely, it is worn out, and a breakdown will follow next.

In order to work properly and the toilet did not create discomfort sensations in the bathroom, the correct installation of the valve flush tank is vital.It is best to select the brand fittings in accordance with the brand toilet.The most high-quality in the market are plumbing devices and parts of the Italian, French and Czech producers.