What should I do if the drain hole does not leave water

Signs quickly fill the sump

main indicators of unsatisfactory work of sewerage system cesspool is:

• silting sides and bottom;
• appearance awful odors;
• organic deposits on the walls of the pit, which is difficult to clean;
• rapid filling of the drain hole.

If your sump appeared silted bottom, it is necessary to take urgent measures to resolve the problem:

1. call professional service sanitation;
2. fill the surface with water to dilute the silting;
3. apply special biological products intended for this purpose.

With the emergence of unpleasant odors from the drainage system to quickly cope special biological preparations.The composition of these microorganisms include septic tanks, which are perfectly cope with organic deposits and at the same time eliminates the smell.There is fast and, most importantly, safe for people, cleaning the sump.

Sump quickly becomes full

Some owners of houses adjoining solve the problem quickly fill the sump, burying her.Next to equip a new surface for the discharge of waste.However, this measure does not solve the problem of rapid filling, much better connection to new and old wells.This increases the discharge space for sewage, and hence double the degree of purification.We should not forget that digging a hole for sewer purposes near drinking water wells prohibited applicable health regulations.This distance shall not be less than 30 meters.

Insulation purification system

In the winter time it is possible to freeze the sump and the entire sewer system.The reason for this may be the lack of insulation.If such a nuisance yet occurred, is a method of quick thawing.However, to use this method need a basic knowledge of the basics of electrical engineering and electrical safety, because it is assumed the use of electric heating conductor materials.

to carry out work to unfreeze the sump need:

• copper wires;
• metal rod length 20cm;
• capture;
• an extension cord.

When connecting the device focuses on electrical safety.A prerequisite is, carrying out work in rubber gloves and insulating footwear.

Warming System is carried out in two variants:

1. If only winter frozen drain pipe, it is wrapped with copper wire.Size of the conductor length is calculated by the formula - 3,14 * D, where D - diameter of the pipe.Thereafter, the device is connected to the power supply, and left for several hours.Under the action of the tube to warm up current and drain it recovers.In this prerequisite is the lack of work near children and pets.
2. When freezing most sump in its center hammered a metal rod and copper wire is connected to it.For applying an electric current to the pin can be used jaw with insulated handle.

After completion of the work in both cases, first disconnect the voltage, and only then remove the wires.