Proper laying bricks - it can not just professionals!

problem of selecting

solution to the brickwork, which will be painted or covered with other materials, problems with joints does not occur.However, for the walls of decorative slate - it is a very urgent problem, because the clutch will always be in sight.Therefore, a thorough approach to the choice of the type of solution seams to be used in a batch, a mixture of the overlay thickness.This is done in order to get the best value for the seam thickness and brick, and an ideal color solution.

Make it quite difficult, and this requires the participation of both the architect and the master who will carry out the work.Various solutions are classified depending on cementing additives are included in their composition.According to these solutions may be divided into several groups:

• mixtures as dry powders;
• mixture is made on the basis of lime;
• Mixtures for performing façade works.

Also, all the solutions are divided into types depending on the mechanical strength.In addition, the cement and distinguish mixed solutions in composition.Focusing on the purpose of use of the composition, it is possible to add various impurities: antifreeze additives, accelerators or retarders time plasticizers.

Note!By selecting the desired type of solution, it is necessary to know clearly the conditions under which will be made brickwork.

How is laying bricks?

Finish facing brick is equivalent to the process of installation of ceramic masonry.In this regard, the bricks must be taken immediately from a variety of packages, just as in the case of ceramics.Laying decorative bricks requires compliance with certain rules:

• necessary to determine the thickness of the seam, the level and the number of stacking layers.To do this, use the rope taut and level to align the outer rows;
• first row is laid "dry" method to validate the future of masonry;
• Always check the level of vertical and horizontal surfaces of lecturing;
• At work you should try to avoid contamination of bricks.

Before you put a brick, it must be lowered into the water - it helps to slow down the drying of the solution, and washes away the dust from all possible material.The mixture should be evenly distributed over the entire surface.Brick solution is placed on getting on and sliding motion against the previous unit to be able to fill the vertical gap.Then tap it hammer for closer cohesion.After placing the entire structure should be covered with polyethylene to protect against possible rain.

Important!Using the dry mixture, carefully read by the use of company-manufacturer's recommendations and the method of mixing.

final work

To better understand how to make masonry bricks, video will become your excellent training material.When most of the work done, you must go to clean masonry.This process should be seen as mandatory, because it is the logical completion of the work.Cleaning is done for two purposes: removal of excess salts from the surface and remove all dirt, mortar residues.These actions must be performed with the following precautions:

• Avoid skin contact with acid materials;
• Avoid contact with acid solutions of metal parts and components.

For cleaning use perchloric acid ten percent solution.Such a mixture is obtained by mixing one part of perchloric acid and nine parts water.After starting the washing process masonry should continue until the entire surface is not yet fully cleared. Important! necessarily need to use protective clothing for this operation.