How to remove vinyl wallpaper , and what tools to use at the same time ?

preparatory stage

Before you think about the question - how to peel vinyl wallpaper, it is important to prepare the space and tools that will be required in the course of work.It is necessary to completely disconnect the room, all switches and sockets are sealed mandatory masking tape.And all bare ends of the wires must be insulated.Ground floor also should be protected from dust and dirt coming.To lay a layer of polyethylene.

Then prepare tools.There is a basic list of tools, but they may differ depending on what has been applied adhesive.Here are the main ones: a bucket, sponge, spatulas of various sizes, the mounting knife, masking tape, iron with steam spray or steam, plastic film, a special device for removing material, hot water or a liquid remover (sold in stores).

Removing old vinyl wallpaper?

Once the room and tools developed can be puzzled by this question - how to strip the vinyl wallpaper.Since vinyl wallpaper consists of two layers - the paper and vinyl, you must make sure that the water has penetrated to the paper layer.This will allow him to be melted and start to flake off.To do this, first make a "cutting" vinyl layer using a roller with needles or knife.Further carried sprinkling.

When the paper layer soaked properly, start to exfoliate and remove the wallpaper edges.At the same time use sharp spatulas (pre-sharpened with sandpaper).Most often difficulty at this stage does not occur, but are often based on several pieces of paper.In these cases it is recommended to put on the surface of the abundant amount of warm water.Then carefully scrape off the residues with a spatula.In some cases, the wallpaper under the influence of water is still not removed.This is especially true of wallpaper made based on polyvinyl chloride.Then it recommends the use of a special liquid.

According to the instructions on the packaging of this mixture taken mixed with water in certain proportions.After some time, this liquid penetrates deep into the place of contact of the base and glue and begins to destroy this layer.After that, the problems with the removal of the coating should not be accurately.Usually, the wallpaper go whole layers. However, it should be remembered that the use of such tools requires special precautions, and careful storage.

There is another very effective method.This use of the steam iron, or with stripping function.Besides, this method prevents contamination of the floor (in the case of fluids can not escape).Under the influence of steam begins to swell and adhesive coating is removed from the surface.

Some recommendations

After represented all existing methods, the question of how to tear vinyl wallpaper should not be.But, sometimes, it is important to follow some recommendations.

• Before removing the cover, it is desirable to study the material and its structure.This allows you to initially select the most suitable method of removing wallpaper.
• moisten the surface of necessary areas, as it is a lengthy process: as long as you remove the coating in one area, the other is all dry.In addition, excessive moisture can lead to the destruction of the plaster layer and will have to re-learn technology plaster walls.
• Eliminate the wallpaper better in the room, from which has been previously taken out all the furniture and appliances.If dust or liquid on the furniture and equipment can negatively affect their appearance and health.
• best to comply with the conditions of temperature and humidity.Humidity should not be too large, and the temperature required plus-only.