Preparation of drawings for the construction of the attic floor

Rebuilding homes for the construction of the attic floor

In order to rebuild the attic under the attic, you must first determine whether the foundation to withstand the additional load on the house will be able to.If the building is being constructed, the calculations it is taken into account.And if it is decided to build on the attic of the house to be restored, it is necessary it must be strengthened.For greater reliability, install additional supports to the building could withstand the heavy load.

When restructuring is necessary to take into account the type of roof.If the roof has a large angle of slope, the room in the attic to get a little.Note that the angle of the roof occupies most of the floor.

Buying a house, taking into account the fact that there will be layered attic, you need to pay attention to the roof.The attic floor is not necessary to build from scratch, it can be converted from the attic.

Calculation of the mansard roof sizes

Height is essential in the construction of the attic floor.If the walls are not high enough, you may have problems with add-in equipment for the living room, because it will be a different furniture, including wardrobes.

Please note that the free movement of people in a room and their safety is considered to be a minimum height of 2.5 m roof If the ceilings, below -. The room is more suitable for the attic, than there is for arrangement of the attic.

In order to ensure the desired height in the superstructure of the line of fracture of the roof should be at a height of not less than 3 m.

buying the necessary material for covering roofs, should draw a detailed plan, which will be designed and painted the roof dimensions, house and room height.

To determine the height of the roof is built floor, you need to consider several factors.If the attic is drawing all reasonably calculated, the add-in to get the most comfortable.

drawing roof attic floor

Before you start rebuilding the attic under the attic or the add an additional floor, it is necessary to do the drawing.It should be specified the exact calculations, which in future will help without too much difficulty to build an extra floor.

to data in the figure were as accurate as possible, you should start with the settlement construction rafters.With a choice of their length should not have any problems, because their size is clearly shown in the building codes.

Gable sloping ceilings the most suitable for the superstructure of the attic.

Note that a broken roof in contrast to the pent roof, increases the load on the walls of the house, so there should be set as much as possible pillars for sufficient reliability.

To build on the attic of the old building must be around the perimeter of the house for extra support.This will help ease the burden on the walls.

The calculations should paint the ventilation system.To the room was not stuffy, you need to decide how the air will circulate in the room.

important part of the drawing is an add-in lighting.For the attic floor will be enough one-stop shop.

Note that skylights provide approximately 40% more light than usual, so it is recommended to install this variant of natural light.

Superstructure height of the window has no size restrictions.But the bottom edge should be at least 90cm.It will also be made to the drawing.

The more precise calculations in the drawing of the attic and the more there are, the more durable and more reliable will superstructure.