Anchor bolt with a ring

Expansion effect of the anchor bolt

ring placing the anchor into the hole, it is necessary to scroll through, and if the bolt is screwed tight, so that it locks into place.

Depending on the wall material should be chosen material for the anchors.

1. steel bolts - for standard fasteners.
2. galvanized steel anchors - not corrode and provides additional protection for walls and structures.
3. Stainless steel anchors - to create strong structures of various modifications.
4. Brass Anchors - corrode and are not suitable for coatings with high humidity.

Dvuhrasporny anchor with a ring to install equipment

Experience shows that expansion anchors are not always successful for the installation of suspended structures.If you need a stronger connection and fastening ponderous structure, should adopt a more perfect way, that is,Innovation dvuhrasporny bolt.It is a threaded bolt on the body konusopodobnoy bolt nut on the stud end.

For this attachment can be used up to three shells.They have konusopodobnuyu shaped and twisted by nesting dolls: one to one.This method makes it possible to extend design and deploy spacers, which will serve as a braking force for the fastener.

In addition, under the ring can be added to solder the nut, which will simplify the installation process and will clamp fasteners more carefully.

for screwing double anchors need to make much effort to overdo it in this case be: a ring and a bolt in any case will not hurt.Fastening produces mostly heavy suspended structures.For example, one can attach a large diameter thick chain and heavy weight.The advantage of this fastening device is a cable ability to withstand high levels of stress.

Securing Manual anchor ring

Step 1: Create the necessary opening for the bolt

Drilling holes - the first thing is to perform high-quality fasteners.Take the hammer with a drill and drill to a depth of the opening of the anchor.

Step 2: cleaning the hole from contamination

natural phenomenon when, after crushing the walls and getting holes in it are fragments and dirt.The remaining dust and dirt must be removed, otherwise they will prevent tight fit sleeve anchor in the hole.For cleaning you can use a vacuum cleaner, brush or hair dryer to completely blow out all the dust and dirt from the wall.

Step 3: Seal fasteners

Insert the anchor into the hole and vtisnite him most deeply.Then, tapping motions hammer hammer it into the hole until it stops.

Step 4: tightening nuts and bursting anchor

Take the wrench and tighten the fasteners to them so that the spacers were opened in the hole and sleeve unclenched.To do this, simply make a few turns of the anchor.Check whether the spacers open, you can also re-rotating the fastener.If the bolt does not rotate, so hardware is fixed.

luck in the assembly and be careful!