Clamp your hands - DIY technology

Homemade clamp - whether it is necessary to contrive such trouble?

Clamp - kind of clip, used for fixing parts or held tightly to each other.It is an indispensable tool without which it can not do, if you want anything cut off, dilute the saw teeth or sharpen it to glue something, and so on.Before, how to clamp , you must know how it is arranged.

most common clamp consists of the following elements: the main frame, the movable element, the jaws, a lever.The movable part by means of thread changes the distance between the jaws device, and the lever allows you to control the clamping force.

There are other varieties of quick-clamping devices such as locking lever assembly.It is based on use leverage and eccentrics.But this device is quite difficult to make at home.

clamp his hands - the stages of manufacture

Described clamp, drawing for the manufacture of which can be easily found on the Internet, going out of the following materials: two studs with 200 mm threaded length and 5 mm in diameter, and two more ofsame cross section, but a length of 120 mm;nuts suitable for them;two plywood boards 15 × 150 × 200 mm and two rails 20 × 40 × 240 mm.Better to use the bars of hard wood such as ash, oak, birch or beech.

This wooden clamp will be attached to the desktop.The bars, which are mounted next to the clamping bench, two holes must be drilled so that the stud with their nuts pinned to each other.For greater stability and structural strength lower bar should be placed flat, and the top - to the edge of the table.

Next set of plywood boards, and it is applied to the bar, which is attached to the table top.The lower edge of plates should be about 3 cm below the bar.All three elements must be drilled through and through: in the resulting holes will subsequently be inserted pins.

After that, one of the planks securely anchored to the bottom bar and the second is the clamping.Thus, the capture will carry the mobile clamp strip of plywood.Short hairpin used to secure the clamp to the table top, and long - determine the stroke of the devices.Nuts act as a lever moving part and the fixing force regulating clamp.

clamp hand - use for the base body hacksaw

Homemade clamps have a tensile strength which is slightly below the store counterparts, but this device will handle the tasks assigned to it, provided proper operation.Manual clamp could also be made of a metal housing handsaw that resembles its shape.

This will require a sliding body hacksaw, two studs with thread and suitable nuts.You just need to insert pins in the connectors clamp body hacksaw.

Nuts are wound on the inside of the housing.The resulting clamp will have two sizes, because the metal frame hacksaw can be decomposed into two positions.Since the tool body is a pull, he will break in two at the middle of the clamping nuts.To prevent this from happening, a folding of the need to tightly wrap the tape.If necessary, from the resulting device can be quickly back to collect hacksaw.