Mnogoschiptsovaya roof is expensive - and greater efficiency ?

What is design?

Gable - is the upper section of the wall, which is limited to two pitched roofs.Below they are not separated by a cornice.If both the upper and lower portions are separated by a cornice, then it will be the front.Gable roof consists of the planes, which are supported on the wall at the same level and are limited to the edges or ends of the forceps.An important structural element of the roof acts valley, which is the interior angle at the joints.

This element is in operation subjected to the strongest influences of precipitation, it accumulates water and snow.Therefore, raising any roof, including mnogoschiptsovuyu, you must pay special attention to the valleys.The simplest mnogoschiptsovaya design - this intersection at right angles of two pitched roofs.The main elements of the design are the mauerlat, beams and rafters.

mauerlat serves to redistribute the load from the roof to the walls of buildings.This element is made of timber section 100x150 or 150x150 mm and a length of 1000-1500 mm.Rafter beams are made of the same cross section, and depending on whether there is additional support or not, and are divided into oblique hanging.At the top of the rafters are joined ridge, which is made from strips or interconnected boards.

Important!Construction mnogoschiptsovyh roof is very complex, and without thorough knowledge of their own building to undertake the construction of such a construction is not recommended.

Mnogoschiptsovaya roof with his hands

mnogoschiptsovoy Erection of roof - is a complex and very important process.This type of roof is considered the most difficult in construction, and are taken only highly qualified specialists for it.In order to start building, the first thing removed house sizes.Then very carefully drawn design, cross-section and the length of the rafter system.It is important at this stage to calculate the location of all rafters, beams and mauerlatov.Also, one should not be mistaken with the seat of all skates, valleys and stops.

Important!Exact calculations of the whole structure - is the key to the reliability of the roof in the future.Therefore, this issue must be approached very seriously.

During the construction of the first thing installed mauerlat - bar, which is laid along the perimeter walls.It serves as a base, "the foundation" for the roof and needs to be securely attached to the wall using anchor bolts.Next set rafter that is inclined beams, which, actually, and will keep the whole roof.Rafters are fastened to mauerlat gashes, nails and staples.If the rafters are large, it is particularly important to make the correct installation of the vertical beams, ties and braces.When the base design is ready, you should begin to install the battens, waterproofing, thermal and vapor barriers and directly to the very roof.

price versus quality

Mnogoschiptsovaya roof - it is not only the most difficult way to the roof of the device, but also, because of the large amount of work and material costs, and even the most expensive option.Construction of a roof will cost at least half the more than another type of roof.But, given that the truss system will keep to myself a lot of weight, you need to purchase only high quality boards for the design and construction often enough to combine two beams into one to strengthen it.

However, if finances permit to build a roof, it will allow the best use of all the space under it.With mnogoschiptsovoy roof makes a wonderful attic and upstairs rooms.It is also very effective in fighting with precipitation, as the roof angle and snow, rain and immediately roll.

Note!Gable roofs are considered to be suitable for small houses as they create extra living space under the roof.